Претраживање
Приказ резултата 1-10 од 88
N-type silicon electron mobility and its relationship to the kink effect for nano-scaled SOI NMOS devices
(Materials Science Forum, 2007)
Electron mobility for the silicon-based devices is one of the most important parameters, which determine the behavior of components. Mobility depends on silicon purity, doping level, presence of lattice defects and electric ...
Microstructural properties of PZT thin films deposited on LaNIQ 3-coated substrates
(Materials Science Forum, 2007)
The modified polymeric precursor method (Pechini method) was successfully used for the preparation of epitaxial and polycrystalline ferroelectric Pb(Zr0.52Ti0.48)O3 (PZT) thin films. Films were deposited on LaNiO3 (LNO) - ...
Vacuum MEMS sensor based on thermopiles - Simple model and experimental results
(Institute of Electrical and Electronics Engineers Inc., 2008)
This paper presents a simple model of MEMS thermopile based vacuum detector and experimental results obtained for sensors designed and fabricated at IHTM-IMTM. Sensors contain two thermopiles, each with 30 multilayer ...
Investigation of silicon anisotropic etching in alkaline solutions with propanol addition
(Institute of Electrical and Electronics Engineers Inc., 2008)
Different propanol isomers additives to 26 wt. % KOH water solution have been studied. It was stated that addition of both isomers result in changing etching anisotropy of (110) oriented corners on Si LT 100 >. For the ...
Preparation of silver(I) complexes with itaconic acid-based hydrogels for biomedical application
(Materials and Manufacturing Processes, 2009)
Silver(I) complexes based on itaconic acid hydrogel were prepared and characterized in order to examine the potential use of these materials. FTIR, AFM, in vitro fluid-uptake, metal sorption, and antibacterial activity ...
Photoacoustic elastic bending method: Investigation of the surface recombination states
(26th International Conference on Microelectronics, Proceedings, MIEL 2008, 2008)
The recombination processes of surface modified Si samples by the PA elastic bending method were investigated. The experimental PA elastic bending signals were measured by using special constructed PA cell (the gas-microphone ...
Non-contact measurement of thickness uniformity of chemically etched Si membranes by fiber-optic low-coherence interferometry
(Institute of Electrical and Electronics Engineers Inc., 2008)
In this paper we present a contactless technique for thickness measurement of chemically etched Si membranes. This technique is based on low-coherence interferometry performed by single-mode fiber-optic sensing configuration. ...
Sulphation of CaO-based sorbent modified in CO2 looping cycles
(Proceedings of the 20th International Conference on Fluidized Bed Combustion, 2009)
CaO-based looping cycles for CO2 capture at high temperatures are based on cyclical carbonation of CaO and regeneration of CaCO3. The main limitation of natural sorbents is the loss of carrying capacity with increasing ...
A consideration of optical noise figures of adsorption-based nanophotonic sensors
(Institute of Electrical and Electronics Engineers Inc., 2008)
We consider some intrinsic noise mechanisms appearing in nanophotonic sensors based on plasmonic structures and surface plasmon-polaritons. We analyze the photonic Johnson-Nyquist fluctuations and the adsorption and ...
A consideration of transparent metal structures for subwavelength diffraction management
(Institute of Electrical and Electronics Engineers Inc., 2006)
We considered theoretically and experimentally one-dimensional multilayered metallodielectric nanofilms with nanometric thickness for imaging below the diffraction limit. We investigated their behavior in the ultravioled ...