Pretraživanje
Prikaz rezultata 1-10 od 32
Electrocatalytic properties and stability of titanium anodes activated by the inorganic sol-gel procedure / Titanske anode aktivirane oksidnom prevlakom dobijenom sol-gel postupkom
(Serbian Chemical Society, 2008)
The properties of activated titanium anodes, RuO2-TiO2/Ti and RuO2--TiO2-IrO2/Ti, prepared from oxide sols by the sol-gel procedure, are reviewed. RuO2 and TiO2 sols were synthesized by forced hydrolysis of the corresponding ...
Characterization of platinum deposited on carbon hollow fibers / carbon cryogel composites
(Journal of Optoelectronics and Advanced Materials, 2008)
Platinum supported on high surface area carbon material is one of the most intensively studied catalysts. However, physicochemical characteristics and surface chemistry of carbon influence properties of the support itself ...
The electrochemical behavior of commercial clarithromycin and spectroscopic detection of its structural changes
(Pleiades Publishing Inc, Moscow, 2008)
The aim of the present study was to examine the behavior of commercial clarithromycin, Clathrocyn (R), comparing to the results previously obtained using pure clarithromycin under the same experimental conditions. The study ...
Process improvement approach to the acid activation of smectite using factorial and orthogonal central composite design methods / Faktorijalni i ortogonalno centralno kompozitni plan eksperimenta kiselinske aktivacije smektita
(Serbian Chemical Society, 2008)
The purpose of this study was to determine the effective operating parameters and the optimum operating conditions of an acid activation process within the framework of improvement of the process. Full two-level factorial ...
Investigation of interface and surface energy states in semiconductors by PA method
(European Physical Journal: Special Topics, 2008)
The photoacoustic (PA) signal should generally change with the extent of damage, in the form of surface energy states (SES) or interface energy states (IES). For a mechanically, chemically or particles processed (Ar-plasma ...
The contributions of high- and low altitude emission sources to the near ground concentrations of air pollutants
(Elsevier Science Inc, New York, 2008)
The scale of transport through the atmosphere depends on the effective height of an emission source, the meteorological conditions and the physico-chemical characteristics of the pollutants. Atmospheric surface temperature ...
The ionic equilibrium in the CuSO4-H2SO4-H2O system and the formation of the honeycomb-like structure during copper electrodeposition / Jonska ravnoteža u sistemu CuSO4-H2SO4-H2O i formiranje strukture pčelinjeg saća elektrohemijskim taloženjem bakra
(Serbian Chemical Society, 2008)
The ionic equilibrium of the species in the CuSO4-H2SO4-H2O system was employed to systematize the conditions of copper electrodeposition leading to the formation of the honeycomb-like structure. The reason why CuSO4 ...
Trans- and cis-resveratrol concentration in wines produced in Serbia / Koncentracija trans- i cis-rezveratrola u vinima proizvedenim u Srbiji
(Serbian Chemical Soc, Belgrade, 2008)
Resveratrol, which occurs in two isomeric forms, trans and cis, is a phytoalexin with numerous pharmacological activities, such as anti-cancer, antiviral, neuroprotective and anti-aging. Red wine is the main source of the ...
Characterization of type III kerogen from Tyrolean shale (Hahntennjoch, Austria) based on its oxidation products / Karakterizacija kerogena tipa III Tirolskog škriljca (Hahntennjoch, Austrija) zasnovana na njegovim oksidacionim proizvodima
(Serbian Chemical Society, 2008)
A 29-step alkaline permanganate degradation of type III kerogen from Tyrolean (Hahntennjoch, Austria) oil shale was performed. A high yield of oxidation products was obtained (93.7 % relative to the original kerogen): 0.5 ...
Surface roughness of ultra-thin silver films sputter deposited on a glass
(Wiley, 2008)
Silver was sputter deposited on a glass with a thin film thickness ranging from 10 to 80 nm. Scanning tunnelling microscopy was used to study the morphology of the obtained Ag-glass surfaces and to estimate the surface ...