Претраживање
Приказ резултата 1-10 од 21
Structural, photoluminescent and photocatalytic properties of TiO2:Eu3+ coatings formed by plasma electrolytic oxidation
(Elsevier, 2016)
In this paper, we used plasma electrolytic oxidation (PEO) of titanium in water solution containing 10 g/L Na3PO4 center dot 12H(2)O + 2 g/L Eu2O3 powder for preparation of TiO2:Eu3+ coatings. The surfaces of obtained ...
The formation of tungsten doped Al2O3/ZnO coatings on aluminum by plasma electrolytic oxidation and their application in photocatalysis
(Elsevier, 2016)
Tungsten doped Al2O3 /ZnO coatings are formed by plasma electrolytic oxidation of aluminum substrate in supporting electrolyte (0.1 M boric acid + 0.05 M borax + 2 g/L ZnO) with addition of different concentrations of ...
Chemical surface composition of the polyethylene implanted by Ag+ ions studied by phase imaging atomic force microscopy
(Elsevier, 2010)
High density polyethylene (HDPE) has been modified by Ag+ ion implantation with the energy of 60 keV. The total amount of implanted silver ions was 1, 5 and 12 x 10(15) ions/cm(2). The surface topography was observed by ...
The antimicrobial efficiency of silver activated sorbents
(Elsevier, 2015)
This study is focused on the surface modifications of the materials that are used for antimicrobial water treatment. Sorbents of different origin were activated by Ag+-ions. The selection of the most appropriate materials ...
Preparation and characterization of novel P(HEA/IA) hydrogels for Cd2+ ion removal from aqueous solution
(Elsevier, 2015)
Series of novel hydrogels based on 2-hydroxyethyl acrylate (HEA) and itaconic acid (IA), P(HEA/IA) copolymers, were prepared by free radical cross-linking copolymerization and investigated as potential adsorbents for Cd2+ ...
Electrochemical behavior of immobilized hemoglobin in alkaline solution
(Elsevier, 2017)
Glassy carbon electrode was modified with different synthesized hybrid clay-based materials and tested in alkaline solution with and without H2O2. The hybrid materials were obtained by immobilizing hemoglobin (Hb) on acid ...
Quantification of the lift height for magnetic force microscopy using 3D surface parameters
(Elsevier, 2010)
In this work, the quantitative conditions for the lift height for imaging of the magnetic field using magnetic force microscopy (MFM) were optimized. A thin cobalt film deposited on a monocrystalline silicon (1 0 0) substrate ...
Effect of UV/ozone treatment on the nanoscale surface properties of gold implanted polyethylene
(Elsevier, 2014)
The effect of ultraviolet (UV) ozone treatment on the surface properties of gold implanted high density polyethylene (HDPE) was investigated at a nanoscale using Atomic Force Microscopy (AFM). HDPE samples were modified ...
Anodic luminescence, structural, photoluminescent, and photocatalytic properties of anodic oxide films grown on niobium in phosphoric acid
(Elsevier, 2015)
This article reports on properties of oxide films obtained by anodization of niobium in phosphoric acid before and after the dielectric breakdown. Weak anodic luminescence of barrier oxide films formed during the anodization ...
The antimicrobial efficiency of silver activated sorbents
(Elsevier, 2015)
This study is focused on the surface modifications of the materials that are used for antimicrobial water treatment. Sorbents of different origin were activated by Ag+-ions. The selection of the most appropriate materials ...