Претраживање
Приказ резултата 1-10 од 24
Electrooxidation of p-nitrophenol using a composite organo-smectite clay glassy carbon electrode
(Elsevier, 2014)
Bentonite clay rich in smectite clay mineral from seldom investigated locality Mecji Do (MD) in Serbia was modified. The organomodification was performed with different loadings of benzyltrimethylammonium (BTMA) cation. ...
Reactively sputtered Ni, Ni(N) and Ni3N films: Structural, electrical and magnetic properties
(Elsevier, 2009)
Nickel thin films were deposited on glass substrates at different N2 gas contents using a dc triode sputtering deposition system. Triode configuration was used to deposit nanostructured thin films with preferred orientation ...
Structural, photoluminescent and photocatalytic properties of TiO2:Eu3+ coatings formed by plasma electrolytic oxidation
(Elsevier, 2016)
In this paper, we used plasma electrolytic oxidation (PEO) of titanium in water solution containing 10 g/L Na3PO4 center dot 12H(2)O + 2 g/L Eu2O3 powder for preparation of TiO2:Eu3+ coatings. The surfaces of obtained ...
Chemical surface composition of the polyethylene implanted by Ag+ ions studied by phase imaging atomic force microscopy
(Elsevier, 2010)
High density polyethylene (HDPE) has been modified by Ag+ ion implantation with the energy of 60 keV. The total amount of implanted silver ions was 1, 5 and 12 x 10(15) ions/cm(2). The surface topography was observed by ...
The formation of tungsten doped Al2O3/ZnO coatings on aluminum by plasma electrolytic oxidation and their application in photocatalysis
(Elsevier, 2016)
Tungsten doped Al2O3 /ZnO coatings are formed by plasma electrolytic oxidation of aluminum substrate in supporting electrolyte (0.1 M boric acid + 0.05 M borax + 2 g/L ZnO) with addition of different concentrations of ...
The antimicrobial efficiency of silver activated sorbents
(Elsevier, 2015)
This study is focused on the surface modifications of the materials that are used for antimicrobial water treatment. Sorbents of different origin were activated by Ag+-ions. The selection of the most appropriate materials ...
Electrochemical behavior of immobilized hemoglobin in alkaline solution
(Elsevier, 2017)
Glassy carbon electrode was modified with different synthesized hybrid clay-based materials and tested in alkaline solution with and without H2O2. The hybrid materials were obtained by immobilizing hemoglobin (Hb) on acid ...
Quantification of the lift height for magnetic force microscopy using 3D surface parameters
(Elsevier, 2010)
In this work, the quantitative conditions for the lift height for imaging of the magnetic field using magnetic force microscopy (MFM) were optimized. A thin cobalt film deposited on a monocrystalline silicon (1 0 0) substrate ...
Anodic luminescence, structural, photoluminescent, and photocatalytic properties of anodic oxide films grown on niobium in phosphoric acid
(Elsevier, 2015)
This article reports on properties of oxide films obtained by anodization of niobium in phosphoric acid before and after the dielectric breakdown. Weak anodic luminescence of barrier oxide films formed during the anodization ...
The thermal stability of porous alumina/stainless steel catalyst support obtained by spray pyrolysis
(Elsevier, 2008)
Active porous alumina coatings were obtained by deposition of boehmite sol on stainless steel (SS) substrate by spray pyrolysis method. The temperature and the doping of polyethylene glycol (PEG) and La3+ in the boehmite ...