Pretraživanje
Prikaz rezultata 1-10 od 11
Multiferroic Heterostructure BaTiO3/ε-Fe2O3 Composite Obtained by in situ Reaction
(Belgrade : International Institute for the Science of Sintering, 2021)
Solid-state reaction between BaTiO3 and Fe2O3 was used to produce a multiferroic heterostructure composite. Commercial BaTiO3 and Fe(NO3)3•9H2O were suspended in ethanol for 30 minutes in an ultrasound bath. The prepared ...
Evaluation of adsorption performance and quantum chemical modeling of pesticides removal using cell-MG hybrid adsorbent
(Belgrade : International Institute for the Science of Sintering (IISS), 2021)
Magnetite (MG) modified cellulose membrane (Cell-MG), obtained by reaction of 3-aminosilane and subsequently with diethylenetriaminepentaacetic acid dianhydride functionalized waste Cell fibers (Cell-NH2 and Cell-DTPA, ...
Novel Magnetic Polymer/bentonite Composite: Characterization and Application for Re(VII) and W(VI) Adsorption
(Belgrade : ETRAN Society, 2021)
A novel magnetic polymer/bentonite composite was prepared by suspension copolymerization of glycidyl methacrylate and ethylene glycol dimethacrylate in the presence of magnetic bentonite (MB-PGME) and functionalized with ...
One-Pot Combustion Synthesis of Nickel Oxide and Hematite: from Simple Coordination Compounds to High Purity Metal Oxide Nanoparticles
(Belgrade : International Institute for the Science of Sintering, 2020)
This work is the first report of a very simple and fast one-pot synthesis of nickel oxide (NiO) and hematite (α-Fe2O3) nanoparticles by thermal decomposition of transition metal aqua complexes with camphor sulfonate anions. ...
Structure and Properties of Nanocrystalline Tetragonal BaTiO3 Prepared by Combustion Solid State Synthesis
(International Institute for the Science of Sintering, 2020)
Barium titanate (BaTiO3) attracts high scientific and technological attention due to good dielectric and electromechanical properties. Although BaTiO3 is one of the most frequently investigated ferroelectric materials, the ...
Valorization of fly ash from a thermal power plant for producing high-performance self-compacting concrete
(International Institute for the Science of Sintering, Beograd, 2020)
This study analyzes the feasibility of valorizing industrial by-product, fly ash from a
thermal power plant as a partial replacement of mineral filler-limestone for the production of
self-compacting concrete (SCC). Three ...
A possible connection between phosphate tungsten bronzes properties and briggs-rauscher oscillatory reaction response
(Belgrade : International Institute for the Science of Sintering (IISS), 2021)
The calcium phosphate tungsten bronze (Ca-PWB) has been synthesized and characterized (TGA, DSC, XRPD, FTIR, SEM). The influence of solid insoluble materials Ca-PWB, as well as lithium doped (Li-PWB) and cation free phosphate ...
Application of Ni(II)-alumina Composites for Electrocatalytic Reduction of 4-nitrophenol
(International Institute for the Science of Sintering, Belgrade, 2020)
Nickel-alumina composites with various content of nickel were synthetized by sol-gel method. The characterization of samples was performed by diffuse reflectance spectroscopy and electrochemical impedance spectroscopy using ...
Macroporous monoliths based оn natural mineral sources, clay аnd diatomite
(Belgrade : Association for ETRAN Society, 2020)
Macroporous silica ceramic was obtained using clay and diatomite. Boric acid as a low-cost additive in the amount of 1 wt% was used. These porous materials were obtained at low forming pressure (40-80 MPa) and lower sintering ...
The Influence of pH on Electrochemical Behavior of Nicotine- Clay based Electrodes
(Belgrade : International Institute for the Science of Sintering (IISS), 2021)
Montmorillonite based clay was acid activated. Nicotine was adsorbed on untreated
and acid activated clay from its aqueous solution at either pH=6 or pH=9.26 (unadjusted pH
solution). The XRD analysis revealed that the ...