Претраживање
Приказ резултата 31-40 од 531
Optimization of micro/nanooscillator parameters for analysis of transient adsorption processes
(Institute of Electrical and Electronics Engineers Inc., 2008)
We consider optimization of parameters of micro/nanooscillators intended for investigation of adsorptiondesorption (AD) processes, which are fast in comparison with the response rate of the oscillator itself. We consider ...
Helium Sensing Using Multipurpose Thermopile-Based MEMS devices
(Institute of Electrical and Electronics Engineers Inc., 2012)
In this paper gas sensing performance of IHTM thermopile-based MEMS sensors is studied both theoretically and experimentally. The sensor has already been proven to be a multipurpose device and this work explores possibilities ...
Modelling of thermopile-based MEMS sensors using analytical and numerical techniques
(27th International Conference on Microelectronics, MIEL 2010 - Proceedings, 2010)
In this paper the thermoelectrical behavior of thermopile-based MEMS sensors is reported using analytical and numerical techniques. It is also shown that experimental results for specific sensors are in excellent agreement ...
A study of water influence on carbon monoxide adsorption and oxidation on nanocrystals of: γ-Fe2O3, Au/Fe2O 3 and MnxZn1-xFe2O4
(Materials Science Forum, 2006)
In this paper the adsorption and oxidation of CO on nanocrystalline Au/γ-Fe2O3, Au/α-Fe2O3, γ-Fe2O3 and a series of mixed ferrite with Mn xZn1-xFe2O4 composition are investigated. The catalysts were prepared by co-precipitation ...
Preparation of ZrO2 and Al2O3 thin-films on stainless steel by spray pyrolysis
(Research Trends in Contemporary Materials Science, 2007)
We have investigated the deposition of ZrO2 and Al2O3 films on a stainless steel (SS) substrate by spray pyrolysis method. The ZrO2 films were deposited from aqueous solution of zirconium dinitrate oxide. For Al2O3 films, ...
Microstructural properties of PZT thin films deposited on LaNIQ 3-coated substrates
(Materials Science Forum, 2007)
The modified polymeric precursor method (Pechini method) was successfully used for the preparation of epitaxial and polycrystalline ferroelectric Pb(Zr0.52Ti0.48)O3 (PZT) thin films. Films were deposited on LaNiO3 (LNO) - ...
Scanning probe-shaped nanohole arrays with extraordinary optical transmission as platform for enhanced surface plasmon-based biosensing
(Institute of Electrical and Electronics Engineers Inc., 2006)
We analyzed the use of subwaveleneth ordered nanohole patterns for detection of miniscule amounts of biological analytes. Owing to their surface plasmon resonance (SPR) operation, such structures show an extraordinarily, ...
Preparation and Characterization of Al2O3 Thin Films for Catalytic Activity Studies
(Nanostructured Materials, Thin Films and Hard Coatings For Advanced Applications, 2010)
In the present work, the surface properties of various Al oxide films were investigated. The oxide films were produced on a stainless steel by spray pyrolysis and cathodic deposition methods. The films obtained represent ...
Synthesis and characterization of octenyl succinic anhydride modified levan
(10th European Symposium on Biopolymers, Straubing, Germany, September 25-27, 2019, Program Abstracts, 2019)
The aim of the present study is to optimize the synthesis of OSA-levan derivative.
A wireless system for liquid level measurement
(8th International Conference on Telecommunications in Modern Satellite, Cable and Broadcasting Servi, 2007)
A wireless system for liquid level measurement is presented. It is developed in order to meet stringent power consumption requirements, but without sacrificing the accuracy of the built-in pressure sensor. The communication ...