Претраживање
Приказ резултата 1-10 од 61
The influence of protective atmosphere on oxidation of sintered SmCo5 magnetic materials
(ETRAN Society, 1996)
Understanding of the thermal stability of intermetallic SmCo5 powder is essential for designing the working atmosphere in all phases of the technological procedure in the production of sintered SmCo5 magnets to obtain ...
The Influence of pH on Electrochemical Behavior of Nicotine- Clay based Electrodes
(Belgrade : International Institute for the Science of Sintering (IISS), 2021)
Montmorillonite based clay was acid activated. Nicotine was adsorbed on untreated
and acid activated clay from its aqueous solution at either pH=6 or pH=9.26 (unadjusted pH
solution). The XRD analysis revealed that the ...
Subwavelength hole arrays with nanoapertures fabricated by scanning probe nanolithography
(International Institute for the Science of Sintering, Beograd, 2006)
Owing to their surface plasmon-based operation, arrays of subwavelength holes show extraordinary electromagnetic transmission and intense field localizations of several orders of magnitude. Thus they were proposed as the ...
Electrochemical and structural properties of Ni(II)-alumina composites as an annealing temperature function
(International Institute for the Science of Sintering, Beograd, 2019)
Alumina powders, pure and doped with nickel, were synthetized by sol-gel method and calcined at 500, 900 and 1100°C in order to obtain mesoporous structures with a high specific surface area, well adapTab. to catalytic ...
Activation Energies as the Validity Criterion of a Model for Complex Reactions that can be in Oscillatory States
(Belgrade: ETRAN – Society for electronics, telecommunication, computing, automatics and nuclear engineering, 2007)
Modeling of any complex reaction system is a difficult task. If the system under examination can be in various oscillatory dynamic states, the apparent activation energies corresponding to different pathways may be of ...
Thermal diffusivity of single crystal Bi0.9Sb0.1
(International Institute for the Science of Sintering, Beograd, 2010)
A single crystal Bi0.9Sb0.1 ingot was synthesized using the Bridgman technique. Thermal diffusivity and electronic transport properties of single crystal cleaved plates (00l) were determined from PA photoacoustic phase and ...
Methods of characterization of multiphase Nd-Fe-B melt-spun alloys
(International Institute for the Science of Sintering, Beograd, 2007)
Nanocomposite permanent magnetic materials based on Nd-Fe-B alloys with a low Nd content are a new type of permanent magnetic material. The microstructure of these nanocomposite permanent magnets is composed of a mixture ...
Macroporous monoliths based оn natural mineral sources, clay аnd diatomite
(Belgrade : Association for ETRAN Society, 2020)
Macroporous silica ceramic was obtained using clay and diatomite. Boric acid as a low-cost additive in the amount of 1 wt% was used. These porous materials were obtained at low forming pressure (40-80 MPa) and lower sintering ...
Influence of the phase composition of refractory materials on creep
(International Institute for the Science of Sintering, Beograd, 2006)
In this paper, the relationship between the creeping effect and mineralogical characteristics of the applied binding phase for various refractory materials (high-alumina materials, with high or low impurity content, tar ...
Investigation of the conditions of synthesis composite optical fiber-magnetic powder
(Sintering Society, 2000)
The goal of these investigations was synthesis of composite optical fiber-magnetic powder with new application possibilities like sensors, detectors etc. The part of results of investigation of the possibility of embedding ...