Pretraživanje
Prikaz rezultata 1-10 od 13
Tensile strength properties of hybrid magnetic composite materials / Zatezna čvrstoća hibridnih magnetnih kompozitnih materijala
(Belgrade, Serbia : Engineering Society for Corrosion, 2017)
The Nd-Fe-B-barium ferrite hybrid composite materials with epoxy matrix presented in this paper cover maximum energy product from 1 to 13 MGOe. Mixture of magnetic particles is responsible for high magnetic quality, while ...
Properties of cotton yarns after oxidation of potassium permanganate in an acidic environment / Svojstva pamučne pređe posle oksidacije kalijum-permanganatom u kiseloj sredini
(Belgrade, Serbia : Engineering Society for Corrosion, 2017)
The impact of nonselective cellulose oxidation (cotton fibre) by potassium permanganate in acidic environment, with or without additional treatment by sodium metabisulfite, on change of sorption (silver ions sorption), and ...
Testing of intergranular and pitting corrosion in sensitized welded joints of austenitic stainless steel
(Serbia : Association of Metallurgical Engineers of Serbia, 2017)
Pitting corrosion resistance and intergranular corrosion of the austenitic stainless steel X5Cr Ni18-10 were tested on the base metal, heat affected zone and weld metal. Testing of pitting corrosion was performed by the ...
The influence of chemical composition on microstructure, hardness and electrical conductivity of Ag-Bi-In alloys at 100 degrees C
(Serbia : Association of Metallurgical Engineers of Serbia AMES, 2017)
Considering possible applications and scarceness of literature data, Ag-Bi-In system was investigated in terms of microstructure, mechanical and electrical properties of ternary alloys from an isothermal section at 100 °C. ...
Ternary Bi-Cu-Ni alloys – thermodynamics, characterization, mechanical and electrical properties
(Serbia : Association of Metallurgical Engineers of Serbia, 2017)
The Bi–Cu–Ni ternary system belongs to the group of potential Cu-Ni-based advanced lead-free solder materials for high temperature application. The paper shows results of the thermodynamic calculations using general solution ...
Mechanical and electrical properties of ternary Ag-Bi-Ga system at 250 °C
(Serbia : Association of Metallurgical Engineers of Serbia, 2017)
This paper presents a comparative review of the experimental and thermodynamic assessment of a ternary Ag-Bi-Ga system. An isothermal section at 250 °C was calculated using optimized thermodynamic data for the constitutive ...
Production of rubber plasticizers based on waste PET: Techno-economical aspect / Sinteza plastifikatora iz otpadnog PET-a za primenu u gumenim proizvodima - tehno-ekonomska analiza
(Belgrade, Serbia : Engineering Society for Corrosion, 2017)
Production of rubber plasticizers, based on waste poly(ethylene terephthalate) (PET), and economic effectiveness of developed technologies are presented and discussed. Waste PET glycolyzates, named diisononyl terephthalate(DINTP), ...
Testing the protective ability of corrosion inhibitors in dilute chloride solutions / Ispitivanje zaštitne sposobnosti inhibitora korozije u razblaženim rastvorima hlorida
(Belgrade, Serbia : Engineering Society for Corrosion, 2017)
After sterilization of meat cans in a factory of meat and meat products in Serbia, occurence of corrosion on the can lids was observed. Sterilization of cans is usually performed in the presence of corrosion inhibitors. ...
Corrosion testing of sa 387 gr. 91 steel
(Society for Structural Integrity and Life, Institute for Material Testing, 2017)
Corrosion behaviour of steel Sa 387 Gr. 91 is tested in solutions containing chloride and sulphate anions. These solutions simulate the conditions of marine and industrial atmosphere. The tests are carried out in a slightly ...
Vertical accuracy of data on the topographic maps and their application in mining
(Institut za rudarstvo i metalurgiju Bor, 2017)
The paper describes some experiences and the methodology used for evaluation the vertical accuracy of data on the official (state) topographic maps. The vertical accuracy is an important element of quality 3D representation ...