Pretraživanje
Prikaz rezultata 31-40 od 58
The Characterization of Sintered SmCo5 Magnets
(Association for ETRAN Society, 1999)
During the investigation and design of laboratory model of a Sintered SmCo5 magnet, a group of methods for characterizing sintered and heat treated magnets was defined. The direct dependence of the magnetic properties of ...
The influence of strontium content and sintering temperature on monazite stability
(Association for ETRAN Society, 2024)
This paper shows a simple way to synthesize a series of Ce1-xSrxPO4 ceramic materials using acetate solutions of Ce and Sr instead of nitrate which were used so far. For synthesis, the preparation method was used by simple ...
Multiferroic Heterostructure BaTiO3/ε-Fe2O3 Composite Obtained by in situ Reaction
(Belgrade : International Institute for the Science of Sintering, 2021)
Solid-state reaction between BaTiO3 and Fe2O3 was used to produce a multiferroic heterostructure composite. Commercial BaTiO3 and Fe(NO3)3•9H2O were suspended in ethanol for 30 minutes in an ultrasound bath. The prepared ...
Effect of Sintering Temperature and Calcium amount on Compressive Strength of Brushite-Metakaolin Polymer Materials
(Association for ETRAN Society, 2022)
The effect of Ca2+ amount and sintering temperature on mechanical properties of geopolymer-brushite (GPB) binders was investigated. Brushite and raw abandoned kaolinite clay thermally transformed into metakaolin were used ...
Characterization of cobalt ferrite nanoparticles obtained by various synthesis methods and comparison with the Raman spectra of other ferrites and some cubic oxide spinels / Kарактеризација наночестица кобалт ферита добијених различитим методама синтезе и поређење са Рамановим спектрима других ферита и неких кубичних оксидних спинела
(Association for ETRAN Society, 2023)
ingle phase cobalt ferrite (CoFe2O4) with nanoparticles of similar sizes (15.7-19 nm) was obtained by different synthesis methods: coprecipitation, ultrasonically assisted coprecipitation, coprecipitation followed by ...
The influence of strontium content and sintering temperature on monazite stability
(Association for ETRAN Society, 2023)
This paper shows a simple way to synthesize a series of Ce1-xSrxPO4 ceramic materials using acetate solutions of Ce and Sr instead of nitrate which were used so far. For synthesis, the preparation method was used by simple ...
Structure and Properties of Nanocrystalline Tetragonal BaTiO3 Prepared by Combustion Solid State Synthesis
(International Institute for the Science of Sintering, 2020)
Barium titanate (BaTiO3) attracts high scientific and technological attention due to good dielectric and electromechanical properties. Although BaTiO3 is one of the most frequently investigated ferroelectric materials, the ...
Fourier-transform infrared spectroscopy analysis of mechanochemical transformation kinetics of sodium carbonate to bicarbonate
(ETRAN Society, 2022)
During mechanical activation, qualitative changes that can produce various phenomena occur in the material. In this study, anhydrous sodium carbonate was mechanically activated for 2, 7, 14, and 28 minutes in a vibro mill ...
Organobentonite: Characterization and Adsorptive Properties towards Phenol and its Derivatives
(International Institute for the Science of Sintering, Beograd, 2016)
Bentonite from Mecji Do locality in Serbia was modified with hexadecyltrimethylammonium bromide (HDTMA-Br), and the sample was denoted as HDTMA-MD. The characterization of the material included X-Ray diffraction, elemental ...
Evaluation of adsorption performance and quantum chemical modeling of pesticides removal using cell-MG hybrid adsorbent
(Belgrade : International Institute for the Science of Sintering (IISS), 2021)
Magnetite (MG) modified cellulose membrane (Cell-MG), obtained by reaction of 3-aminosilane and subsequently with diethylenetriaminepentaacetic acid dianhydride functionalized waste Cell fibers (Cell-NH2 and Cell-DTPA, ...