Претраживање
Приказ резултата 1-10 од 39
Identification of intermetallic compounds in thin layers of electrodeposited Cu–Cd alloys using electrochemical techniques
(USA :Taylor & Francis INC, 1991)
An attempt was made to analyse the phase structure of thin layers of electrodeposited Cu–Cd alloys using anodic linear sweep voltammetry combined with a potentiostatic pulse technique (ALSV–PPT). The results were compared ...
Effect of codeposition of polymer on the morphology of electrodeposited copper
(Kluwer Academic Publishers, 1979)
Poly(4-vinyl pyridine-co-methyl methacrylate), which is soluble in water in its protonated form and insoluble as a neutral molecule, has been synthesized and introduced into an acid bath for copper deposition. Potential-sweep ...
The effects of the pause to pulse ratio in the regime of pulsating overpotential on the formation of honeycomb-like structures
(Elsevier Science Inc, New York, 2009)
The formation of honeycomb-like structures in the pulsating overpotential (PO) regime was examined by scanning electron microscopy (SEM). The honeycomb-like structures obtained with a square-wave PO of different pause to ...
Anodic deposition of colloidal gold
(Elsevier, 1984)
Colloidal gold solutions were prepared following classical recipes. When electrolysed between graphite electrodes, gold was found to deposit at the anode. The rate of deposition was dependent on the anode potential, on the ...
Comparison of open porous copper structures obtained by the different current regimes of electrolysis
(Elsevier, 2012)
Formation of open porous copper structures by the electrodeposition processes in the hydrogen code-position range was considered. Morphologies of copper deposits obtained by the reversing current (RC) regimes at the same ...
Fundamental aspects of pulsating current metal electrodeposition VIII: The effect of pause-to-pulse ratio on microthrowing power of metal deposition
(Elsevier, 1984)
The effect of a pulsating current on the microthrowing power of metal deposits in the early stage of deposition was investigated by scanning electron microscopy. It is shown that at the same average current density the ...
A Novel Route for Electrolytic Production of Very Branchy Copper Dendrites under Extreme Conditions
(IOP Publishing Limited, 2021)
Copper electrodeposition in a form of powder was examined using the pulsating overpotential (PO) regime from the sulfate electrolyte without or with an addition of various concentrations of chloride ions. Morphological and ...
Influence of the complex formation on the morphology of lead powder particles produced by the electrodeposition processes
(Elsevier, 2013)
The processes of lead electrodeposition from the basic (nitrate) and complex (acetate) electrolytes were mutually compared by the analysis of their polarization characteristics and by the scanning electron microscopic (SEM) ...
Fundamental aspects of pulsating current metal electrodeposition IX: The prevention of spongy deposit formation on inert substrates
(Elsevier, 1984)
It is shown that spongy deposits are obtained under d.c. conditions and that compact deposits are obtained in pulsating current (PC) deposition with high pause-to-pulse ratios at the same average current density and ...
A new insight into the mechanism of lead electrodeposition: Ohmic-diffusion control of the electrodeposition process
(Elsevier, 2013)
A new insight into the mechanism of lead electrodeposition from nitrate solutions is presented by analysis of the polarization characteristics and by scanning electron microscopic (SEM) analysis of the surface morphology ...