Претраживање
Приказ резултата 1-10 од 40
Formation of dish-like holes and a channel structure in electrodeposition of copper under hydrogen co-deposition
(Elsevier, 2007)
Copper electrodeposition from acid sulfate solutions at an overpotential of 1000 mV, which is about 250 mV outside the plateau of the limiting diffusion current density, was examined by the determination of the average ...
Ballistic magnetoresistance versus magnetostriction effects in electrodeposited nanocontacts at room temperature
(Institute of Electrical and Electronics Engineers, Inc., 2003)
The authors present experiments and discuss recent results on ballistic magnetotesistance in nanometer size (on the order of 1 to 10 nm) nanocontacts grown by electrodeposition in
thin wires and in thin films of a few ...
Formation of needle-like and honeycomb-like magnesium oxide/hydroxide structures by electrodeposition from magnesium nitrate melts
(Oxford : Pergamon-Elsevier Science Ltd, 2018)
The processes of electrochemical deposition of magnesium oxide/hydroxide on glassy carbon (GC) electrode from magnesium nitrate hexahydrate melt have been investigated. A novel procedure predicting a possibility of direct ...
A new insight into the mechanism of lead electrodeposition: Ohmic-diffusion control of the electrodeposition process
(Elsevier, 2013)
A new insight into the mechanism of lead electrodeposition from nitrate solutions is presented by analysis of the polarization characteristics and by scanning electron microscopic (SEM) analysis of the surface morphology ...
Fundamental aspects of pulsating current metal electrodeposition VIII: The effect of pause-to-pulse ratio on microthrowing power of metal deposition
(Elsevier, 1984)
The effect of a pulsating current on the microthrowing power of metal deposits in the early stage of deposition was investigated by scanning electron microscopy. It is shown that at the same average current density the ...
The Preferred Orientation of Bright Copper Deposits
(Switzerland : Trans Tech Publications Ltd, 2000)
The preferred orientations of copper deposits obtained from acid sulfate solutions were examined. Mat deposits obtained in the absence of the additives and in the presence of disodium 2-naphtol-3,6-disulfonic acid possessed ...
Anodic deposition of colloidal gold
(Elsevier, 1984)
Colloidal gold solutions were prepared following classical recipes. When electrolysed between graphite electrodes, gold was found to deposit at the anode. The rate of deposition was dependent on the anode potential, on the ...
Influence of the complex formation on the morphology of lead powder particles produced by the electrodeposition processes
(Elsevier, 2013)
The processes of lead electrodeposition from the basic (nitrate) and complex (acetate) electrolytes were mutually compared by the analysis of their polarization characteristics and by the scanning electron microscopic (SEM) ...
Effect of parameters of square-wave pulsating current on copper electrodeposition in the hydrogen co-deposition range
(Elsevier Science Inc, New York, 2010)
Copper electrodeposition processes in the hydrogen co-deposition range by the pulsating current (PC) regime were examined by the determination of the average current efficiency of hydrogen evolution and by the scanning ...
Nanostructural Analysis of Mirror – Bright Zinc Coatings
(MAIK "Nauka /Interperiodica" (Russia), 2006)
The zinc coatings electrode posited from solution containing dextrin/salicyl aldehyde mixture are
examined by the scanning tunneling microscopy (STM). It is shown that mirror brightness of these zinc deposits is associated ...