Претраживање
Приказ резултата 31-40 од 46
Electrochemical aspects of formation of dendrites / Elektrohemijski aspekti formiranja dendrita
(Belgrade, Serbia : Engineering Society for Corrosion, 2016)
The one of the main contributions of Belgrade Electrochemical School to the field of metal electrodeposition is investigation of a mechanism of formation and growth of the disperse deposits. Spongy-like, cauliflower-like, ...
PtAu catalyst with enhanced activity for formic acid oxidation / PtAu katalizator sa poboljšanom aktivnošću za reakciju oksidacije mravlje kiseline
(Belgrade, Serbia : Engineering Society for Corrosion, 2018)
PtAu systems are recognized as good catalysts for the oxidation of formic acid electrooxidation, which is investigated as a possible anodic reaction in low-temperature fuel cells. In this research, bimetallic PtAu ...
Testing the protective ability of corrosion inhibitors in dilute chloride solutions / Ispitivanje zaštitne sposobnosti inhibitora korozije u razblaženim rastvorima hlorida
(Belgrade, Serbia : Engineering Society for Corrosion, 2017)
After sterilization of meat cans in a factory of meat and meat products in Serbia, occurence of corrosion on the can lids was observed. Sterilization of cans is usually performed in the presence of corrosion inhibitors. ...
Determination of the weld metal corrosion rate using electrochemical techniques / Određivanje brzine korozije metala šava u zavarenom spoju pomoću elektrohemijskih tehnika
(Belgrade, Serbia : Engineering Society for Corrosion, 2015)
To determine corrosion rate of the base metal and weld metal were applied electrochemical techniques: linear polarization resistance, linear sweep voltammetry and electrochemical impedance spectroscopy. The samples were ...
Chemical corrosion of metals and alloys / Hemijska korozija metala i legura
(Belgrade, Serbia : Engineering Society for Corrosion, 2016)
In this paper, phenomena of chemical corrosion of metals and alloys in electrolyte solutions are analyzed. It is shown that iron, chromium and other metals and alloys dissolve much faster than is the corrosion rate determined ...
Influence of the synthesis procedures on pt catalyst activity for ethanol electrooxidation reaction / Uticaj postupka sinteze na aktivnost platinskih katalizatora za reakciju elektrooksidacije etanola
(Belgrade, Serbia : Engineering Society for Corrosion, 2016)
Carbon supported platinum catalysts for ethanol electrooxidation were synthesized by modified polyol synthesis method, assisted by microwave or reflux heating. Synthesized catalysts were characterized by XRD, STM and TGA ...
Morphology of Fe-Ni alloy powders electrodeposited from citrate-sulfate containing solutions / Morfologija prahova Fe-Ni legura elektrohemijski istaloženih iz citratno-sulfatnih rastvora
(Belgrade, Serbia : Engineering Society for Corrosion, 2011)
The electrochemical deposition of the Fe-Ni alloy powders from citrate-sulfate containing electrolytes of different Ni/Fe ions concentration ratios at pH 4.5 was examined by the polarization measurements. All polarization ...
Water quality as one of the possible causative agents of corrosion in thermal power plants / Kvalitet vode kao jedan od mogućih uzročnika korozije u termoenergetskim postrojenjima
(Belgrade, Serbia : Engineering Society for Corrosion, 2010)
Damage and cancellations of thermal power plants in large numbers are caused due to an inadequate quality of feed water, which occur due to different types of corrosion processes. Water is a good solvent and its chemical ...
Correlation between crystal orientation and morphology of electrolytically produced powder particles: Analysis of the limiting cases / Korelacija izmedju orijentacije kristala i morfologije elektrolitički proizvedenih praškastih čestica - analiza graničnih slučajeva
(Belgrade, Serbia : Engineering Society for Corrosion, 2018)
Lead and nickel powder particles were produced by the processes of electrolysis and characterized by scanning electron microscope (SEM). The X-ray diffraction (XRD) analysis of the produced particles was done. Morphologies ...
Formation and growth of pits on X5CrNi18-10 austenitic stainless steel in presence of chlorides and sulphates / Formiranje i rast pitova na austenitnom nerđajućem čeliku X5CrNi18-10 u prisustvu hlorida i sulfata
(Belgrade, Serbia : Engineering Society for Corrosion, 2018)
The resistance of X5CrNi18-10 stainless steel to pitting corrosion in a solution containing chlorides and sulphates was tested using the potentiodynamic polarization method. The obtained results show that the stainless ...