Претраживање
Приказ резултата 61-70 од 894
Evidence of stability of sedimentary organic matter during bacterial desilicification of an oil shale / Dokaz o postojanosti sedimentne organske supstance pri bakterijskoj desilicifikaciji jednog uzorka bituminoznog škriljca
(Serbian Chemical Society, 2001)
Aleksinac oil shale organic matter appeared to remain unchanged, according to elemental, IR, P-GC and P-GC-MS analytical characterization, after exposure to Bacillus circulans-Jordan desilicification for 30 days. These ...
Surface roughness minimum: Ag thin layer deposited on a glass / Minimum površinske hrapavosti: tanki sloj Ag deponovan na staklu
(Belgrade : Serbian Chemical Society, 2001)
In this paper the results of an examination of the surface roughness and morphology dependence of silver thin films up to 100 nm thick deposited on a microscope glass on the deposition rate and on the deposition time are ...
Adhesion of epoxy cataphoretic coatings on Zn alloys / Адхезија епоксидних катафоретских превлака на легурама цинка
(Belgrade : Serbian Chemical Society, 2007)
One of the most important factors in corrosion prevention by protective coatings is the loss of coating adhesion under environmental influence. In this work, the adhesion of epoxy cataphoretic coatings was examined on steel ...
Preliminary Analysis of Quality of Contour Lines Using Smoothing Algorithms
(Croatia : Faculty of Mechanical Engineering in Slavonski BrodCroatia : Faculty of Electrical Engineering in OsijekCroatia : Faculty of Civil Engineering in Osijek, 2019)
In this paper several well-known filtering techniques were compared in the purpose of automatic line generalization. The used methods for line simplification are digital first order low-pass filter, Savitzky-Golay (SG) ...
Porous glycidyl methacrylate-bentonite composite
(Maik Nauka/Interperiodica/Springer, New York, 2011)
Crosslinked macroporous copolymer of glycidyl methacrylate and ethylene glycol dimethacrylate (CP) and copolymer composite with acid modified clay (CP-S-A) were prepared by radical suspension copolymerization and functionalized ...
Characterization of copper powder particles obtained by electrodeposition as function of different current densities
(Journal of Applied Electrochemistry, 2009)
Technological properties of powders depend on their granulometry and morphology. Very often one method is inadequate for characterization of powder particles. This article studied different methods intended for clear ...
A trapezoidal microstrip bandstop filter with efficient suppression of undesired stopbands
(National Institute of Optoelectronics, 2010)
A new bandstop filter implemented as a cascade of trapezoidally shaped cells is presented. The proposed bandstop filter suppresses many undesired stopbands at higher frequencies. The cell design is specified by two variables ...
Mutual influence of parallel, CH/O, OH/pi and lone pair/pi interactions in water/benzene/water system
(Elsevier, 2013)
The mutual influence of OH/pi, CH/O, parallel alignment (all attractive) and lone pair/pi (repulsive) water/benzene interactions was studied with ab initio calculations on water/benzene/water systems. The energies of the ...
Process improvement approach to the acid activation of smectite using factorial and orthogonal central composite design methods / Faktorijalni i ortogonalno centralno kompozitni plan eksperimenta kiselinske aktivacije smektita
(Serbian Chemical Society, 2008)
The purpose of this study was to determine the effective operating parameters and the optimum operating conditions of an acid activation process within the framework of improvement of the process. Full two-level factorial ...
Decorated Ru/Au(111) and Os/Au(111) surfaces: An in situ STM and electrochemistry study
(Russia : Maik Nauka-Interperiodica Publishing, 2006)
The structure and reactivity of bimetallic electrodes obtained by spontaneous deposition of Ru and Os on Au(111) single-crystal surfaces are studied. In situ electrochemical STM and cyclic voltammetry are used to characterize ...