Претраживање
Приказ резултата 11-20 од 60
A comparative thermomagnetic study of melt-spun Nd-Fe-B alloys with different Nd content
(International Institute for the Science of Sintering, Beograd, 2009)
Changes in the phase composition and magnetic properties of three types of commercial Nd-Fe-B alloys with different Nd content - low (10-12 wt%), near stoichiometric (21-25 wt%) and rich (26-29 wt%) caused by thermomagnetic ...
Cyclic Voltammetric Study of the Influence of Porosity on Electrochemical Response of Nickel-Alumina Modified Glassy Carbon Electrode
(International Institute for the Science of Sintering, Beograd, 2018)
Pure and nickel-modified alumina powders with different porosity were synthesized and applied on the glassy carbon electrode by means of Nafion polymer. The data obtained from the nitrogen adsorption-desorption isotherm ...
Microstructure refinement and physical properties of Ag-SnO2 based contact materials prepared by high-energy ball milling
(International Institute for the Science of Sintering, Beograd, 2013)
High energy ball milling was used in order to improve dispersion of metal oxide in Ag-SnO2 electrical contact materials. The processed Ag-SnO2 (92:8) and Ag-SnO2In2O3 (87.8:9.30:2.9) powder mixtures were subsequently ...
Electrochemical and structural properties of Ni(II)-alumina composites as an annealing temperature function
(International Institute for the Science of Sintering, Beograd, 2019)
Alumina powders, pure and doped with nickel, were synthetized by sol-gel method and calcined at 500, 900 and 1100°C in order to obtain mesoporous structures with a high specific surface area, well adapTab. to catalytic ...
Effect оf delamination оn physico-chemical properties оf kaolin
(International Institute for the Science of Sintering (IISS), 2021)
To provide the quality required for its use, raw kaolin must be subjected to certain processing procedures like delamination which is applied to the layered structure materials. The aim of this research is to determine the ...
Methods of characterization of multiphase Nd-Fe-B melt-spun alloys
(International Institute for the Science of Sintering, Beograd, 2007)
Nanocomposite permanent magnetic materials based on Nd-Fe-B alloys with a low Nd content are a new type of permanent magnetic material. The microstructure of these nanocomposite permanent magnets is composed of a mixture ...
Subwavelength hole arrays with nanoapertures fabricated by scanning probe nanolithography
(International Institute for the Science of Sintering, Beograd, 2006)
Owing to their surface plasmon-based operation, arrays of subwavelength holes show extraordinary electromagnetic transmission and intense field localizations of several orders of magnitude. Thus they were proposed as the ...
Thermal diffusivity of single crystal Bi0.9Sb0.1
(International Institute for the Science of Sintering, Beograd, 2010)
A single crystal Bi0.9Sb0.1 ingot was synthesized using the Bridgman technique. Thermal diffusivity and electronic transport properties of single crystal cleaved plates (00l) were determined from PA photoacoustic phase and ...
Synthesis of Highly Porous Al2O3-YAG Composite Ceramics
(International Institute for the Science of Sintering, Beograd, 2016)
Al2O3-YAG composite was obtained by sintering of porous Al2O3 preforms infiltrated with water solution of aluminium nitrate nonahydrate, Al(NO3)(3)center dot 9H(2)O and yttrium nitrate hexahydrate, Y(NO3)(3)center dot ...
Investigation of the conditions of synthesis composite optical fiber-magnetic powder
(Sintering Society, 2000)
The goal of these investigations was synthesis of composite optical fiber-magnetic powder with new application possibilities like sensors, detectors etc. The part of results of investigation of the possibility of embedding ...