Pretraživanje
Prikaz rezultata 1-10 od 56
Macroporous monoliths based оn natural mineral sources, clay аnd diatomite
(Belgrade : Association for ETRAN Society, 2020)
Macroporous silica ceramic was obtained using clay and diatomite. Boric acid as a low-cost additive in the amount of 1 wt% was used. These porous materials were obtained at low forming pressure (40-80 MPa) and lower sintering ...
The influence of protective atmosphere on oxidation of sintered SmCo5 magnetic materials
(ETRAN Society, 1996)
Understanding of the thermal stability of intermetallic SmCo5 powder is essential for designing the working atmosphere in all phases of the technological procedure in the production of sintered SmCo5 magnets to obtain ...
Ecologically Friendly Chitosan-montmorillonite Bio-nanocomposite as Adsorbent for Textile Dyes from Aqueous Solutions
(International Institute for the Science of Sintering, Beograd, 2017)
The bio-nanocomposite of montmorillonite and natural biopolymer chitosan (C-MM) was synthesized. Intercalation of chitosan in form of monolayer into the interlamellar space of montmorillonite was confirmed by XRD and IR ...
State of the Art and Challenges in Development of Electrical Contact Materials in the Light of the RoHS Directive
(International Institute for the Science of Sintering, Beograd, 2012)
The article surveys current state of the art and challenges in the development of the electrical contact materials in the light of the EU Directive on Restriction of Hazardous Substances (RoHS). The focus was placed on ...
Two Step Sintering of ZnTiO3 nanopowder
(International Institute for the Science of Sintering, Beograd, 2017)
Metastable nanopowder ZnTiO3 was pressed into cylindrical compacts at 200 MPa. Compacts were treated by conventional heating with isothermal holding at 931 degrees C for 10 minutes, 25 minutes and 40 minutes. ZnTiO3 compacts ...
Magnetic properties of ND Rich Melt-Spun ND-FE-B alloy
(International Institute for the Science of Sintering, Beograd, 2005)
As a part of these experimental investigations of melt-spun Nd-Fe-B alloy with Nd rich content in relation to Nd2Fe14B prepared by rapid quenching process for optimally selected cooling rate and heat treatment, the influence ...
Influence of the phase composition of refractory materials on creep
(International Institute for the Science of Sintering, Beograd, 2006)
In this paper, the relationship between the creeping effect and mineralogical characteristics of the applied binding phase for various refractory materials (high-alumina materials, with high or low impurity content, tar ...
Methanol electrooxidation on PtRu modified zeolite X
(International Institute for the Science of Sintering, Beograd, 2013)
Zeolite NaX (faujasite type) was used as a support for platinum-ruthenium catalyst. A procedure for thermal decomposition of noble metal acetylacetonates to deposit noble metal clusters on the surface of solid support was ...
Study of Nd-Fe-B alloys with nonstoichiometric Nd content in optimal magnetic state
(International Institute for the Science of Sintering, Beograd, 2009)
Characterization of two rapid-quenched Nd-Fe-B alloys with nonstoichiometric Nd content in the optimized magnetic state was carried out using the X-ray diffractometry (XRD), 57Fe Mössbauer spectroscopic phase analysis (MS), ...
Formation of Magnetic Microstructure of the Nanosized NiFe2O4 Synthesized Via Solid-State Reaction
(International Institute for the Science of Sintering, Beograd, 2012)
Magnetic NiFe2O4 structure formation was studied through structural, compositional and magnetic characterization of obtained reaction products of a simple, high yielding and low-cost solid-state reaction. Initial annealing ...