Претраживање
Приказ резултата 1-10 од 16
Determination of silanol end groups in polysiloxanes obtained from dimethyldichlorosilane hydrolysate (DDSH) / Odredjivanje silanolnih krajnjih grupa u polisiloksanima dobijenim iz dimetildihlorsilan hidrolizata (ddsh)
(Serbian Chemical Society, 2006)
Dimethyldichlorosilane hydrolysate, DDSH, the linear part of which contains SiOH end groups, can be used in the preparation of difunctionally terminated (any end groups other than SiOH) polysiloxanes via equilibration ...
Prediction of the particle circulation rate in a draft tube spouted bed suspension dryer / Predviđanje cirkulacije čestica u sušioniku za suspenzije sa modifikovanim fontanskim slojem
(Serbian Chemical Society, 2006)
A model for predicting the particle circulation rate in a draft tube spouted bed dryer with inert particles is proposed and verified. The calculation algorithm requires three input values: the gas velocity in the draft ...
The chemical characteristics of soil which determine phosphorus partitioning in highly calcareous soils / Hemijske karakteristike visoko-krečnjačkih zemljišta koje određuju raspodelu fosfora
(Serbian Chemical Society, 2006)
Phosphorus fractions from three highly calcareous soils (average, 24.9 ± 4.8 %CO3 2-) from sampling sites with a Mediterranean climate were isolated by sequential extraction. In order to provide a more reliable basis for ...
The effect of perpendicularly oriented magnetic field on the formation of very disperse iron structures / Uticaj vertikalno orijentisanog magnetnog polja na formiranje veoma disperznih struktura gvožđa
(Serbian Chemical Society, 2006)
Iron deposits obtained without and with a perpendicularly oriented magnetic field were examined by scanning electron microscopy (SEM). It was found that the iron deposit obtained under a perpendicularly oriented magnetic ...
The HPLC determination of the content of magnoflorine in Epimedium alpinum L. / HPLC одређивање садржаја магнофлорина у преволцу Epimedium alpinum L.
(Serbian Chemical Society, 2006)
The aporphine alkaloid magnoflorine, known as a constituent of Asian Epimedium species, was isolated for the first time from the wild growing European species, Epimedium alpinum L. Identification was done by comparison ...
Corrosion potential of 304 stainless steel in sulfuric acid / Korozioni potencijal nerđajućeg čelika 304 u sumpornoj kiselini
(Serbian Chemical Society, 2006)
The potentiodynamic study of the electrochemical behavior of austenitic 304 stainless steel in deaerated aqueous sulfuric acid of pH 1 revealed that the steel achieved a stable corrosion potential of ca. - 0.350 V (SCE) ...
Influence of chloride ions on the open circuit potentials of chromium in deaerated sulfuric acid solutions / Uticaj hloridnih jona na potencijal otvorenog kola hroma u deaerisanim rastvorima sumporne kiseline
(Serbian Chemical Society, 2006)
Open circuit potential measurements and cyclic voltammetry of chromium in deaerated aqueous H2SO4 solution of pH 1 without and containing NaCl in the concentration range 0.5 - 4 M revealed that chromium exhibits two stable ...
Activity and stability of RuO2-coated titanium anodes prepared via the alkoxide route / Aktivnost i stabilnost titanskih anoda sa prevlakom od oksida rutenijuma dobijenom alkoksidnim postupkom
(Serbian Chemical Society, 2006)
Titanium anodes with an active RuO2 coating of two different thicknesses were prepared from the oxide suspended in ethanol ("ink" method), while the oxide itself was synthesized by the hydrolysis of ruthenium ethoxide in ...
Methanol oxidation at platinum electrodes in acid solution: Comparison between model and real catalysts / Oksidacija metanola na platinskim elektrodama u kiseloj sredini - poređenje model i realnih katalizatora
(Serbian Chemical Society, 2006)
Methanol oxidation in acid solution was studied at platinum single crystals, Pt(hkl), as the model catalyst, and at nanostructural platinum supported on high surface area carbon, Pt/C, as the real catalyst. The linear ...
Physical modeling of representative particles of electrodeposited copper powders / Fizičko modelovanje reprezentativnih čestica elektrohemijski istaloženog bakarnog praha
(Serbian Chemical Society, 2006)
A method for the estimation of the size of the representative particle of a copper powder is given. Cross sections of representative particles of flowing and non-flowing powders estimated by this procedure are also presented.