Претраживање
Приказ резултата 1-10 од 23
Macroporous monoliths based оn natural mineral sources, clay аnd diatomite
(Belgrade : Association for ETRAN Society, 2020)
Macroporous silica ceramic was obtained using clay and diatomite. Boric acid as a low-cost additive in the amount of 1 wt% was used. These porous materials were obtained at low forming pressure (40-80 MPa) and lower sintering ...
Effect оf delamination оn physico-chemical properties оf kaolin
(International Institute for the Science of Sintering (IISS), 2021)
To provide the quality required for its use, raw kaolin must be subjected to certain processing procedures like delamination which is applied to the layered structure materials. The aim of this research is to determine the ...
The Influence of pH on Electrochemical Behavior of Nicotine- Clay based Electrodes
(Belgrade : International Institute for the Science of Sintering (IISS), 2021)
Montmorillonite based clay was acid activated. Nicotine was adsorbed on untreated
and acid activated clay from its aqueous solution at either pH=6 or pH=9.26 (unadjusted pH
solution). The XRD analysis revealed that the ...
Structure and Properties of Nanocrystalline Tetragonal BaTiO3 Prepared by Combustion Solid State Synthesis
(International Institute for the Science of Sintering, 2020)
Barium titanate (BaTiO3) attracts high scientific and technological attention due to good dielectric and electromechanical properties. Although BaTiO3 is one of the most frequently investigated ferroelectric materials, the ...
Multiferroic Heterostructure BaTiO3/ε-Fe2O3 Composite Obtained by in situ Reaction
(Belgrade : International Institute for the Science of Sintering, 2021)
Solid-state reaction between BaTiO3 and Fe2O3 was used to produce a multiferroic heterostructure composite. Commercial BaTiO3 and Fe(NO3)3•9H2O were suspended in ethanol for 30 minutes in an ultrasound bath. The prepared ...
Effect of Sintering Temperature and Calcium amount on Compressive Strength of Brushite-Metakaolin Polymer Materials
(Association for ETRAN Society, 2022)
The effect of Ca2+ amount and sintering temperature on mechanical properties of geopolymer-brushite (GPB) binders was investigated. Brushite and raw abandoned kaolinite clay thermally transformed into metakaolin were used ...
Characterization of cobalt ferrite nanoparticles obtained by various synthesis methods and comparison with the Raman spectra of other ferrites and some cubic oxide spinels / Kарактеризација наночестица кобалт ферита добијених различитим методама синтезе и поређење са Рамановим спектрима других ферита и неких кубичних оксидних спинела
(Association for ETRAN Society, 2023)
ingle phase cobalt ferrite (CoFe2O4) with nanoparticles of similar sizes (15.7-19 nm) was obtained by different synthesis methods: coprecipitation, ultrasonically assisted coprecipitation, coprecipitation followed by ...
The influence of strontium content and sintering temperature on monazite stability
(Association for ETRAN Society, 2023)
This paper shows a simple way to synthesize a series of Ce1-xSrxPO4 ceramic materials using acetate solutions of Ce and Sr instead of nitrate which were used so far. For synthesis, the preparation method was used by simple ...
Fourier-transform infrared spectroscopy analysis of mechanochemical transformation kinetics of sodium carbonate to bicarbonate
(ETRAN Society, 2022)
During mechanical activation, qualitative changes that can produce various phenomena occur in the material. In this study, anhydrous sodium carbonate was mechanically activated for 2, 7, 14, and 28 minutes in a vibro mill ...
One-Pot Combustion Synthesis of Nickel Oxide and Hematite: from Simple Coordination Compounds to High Purity Metal Oxide Nanoparticles
(Belgrade : International Institute for the Science of Sintering, 2020)
This work is the first report of a very simple and fast one-pot synthesis of nickel oxide (NiO) and hematite (α-Fe2O3) nanoparticles by thermal decomposition of transition metal aqua complexes with camphor sulfonate anions. ...