Претраживање
Приказ резултата 1-10 од 30
Evidence of stability of sedimentary organic matter during bacterial desilicification of an oil shale / Dokaz o postojanosti sedimentne organske supstance pri bakterijskoj desilicifikaciji jednog uzorka bituminoznog škriljca
(Serbian Chemical Society, 2001)
Aleksinac oil shale organic matter appeared to remain unchanged, according to elemental, IR, P-GC and P-GC-MS analytical characterization, after exposure to Bacillus circulans-Jordan desilicification for 30 days. These ...
Surface roughness minimum: Ag thin layer deposited on a glass / Minimum površinske hrapavosti: tanki sloj Ag deponovan na staklu
(Belgrade : Serbian Chemical Society, 2001)
In this paper the results of an examination of the surface roughness and morphology dependence of silver thin films up to 100 nm thick deposited on a microscope glass on the deposition rate and on the deposition time are ...
Characterization and corrosion properties of electrodeposited Ni-W alloys / Karakterizacija i korozione karakteristike elektrohemijski taložene legure Ni-W
(Serbian Chemical Society, 2001)
Ni-W alloys electrodeposited from citrate solution consist of three different phases, which are all present in high W-content alloys: a solid solution of W in a Ni matrix; an intermetallic compound Ni4W, as well as another ...
Carbon monoxide oxidation on bimetallic Ru/Au(111) surfaces / Оксидација CO на биметалним Ru/Au(111) површинама
(Belgrade : Serbian Chemical Society, 2001)
The electrochemical deposition of Ru on Au(111) was performed in 0.5 M H2SO4 + 10-4 M RuCl3. The obtained bimetallic Ru/Au(111) surfaces were characterised by cyclic voltammetry and in situ STM in 0.5 M H2SO4. The Ru deposit ...
The effect of the composition of the dispersing medium of oxide sols on the electrocatalytic activity of sol-gel obtained RuO2-TiO2/Ti anodes / Uticaj sastava disperzne sredine oksidnih solova na elektrokatalitičku aktivnost RuO2-TiO2/Ti anoda dobijenih sol-gel postupkom
(Serbian Chemical Society, 2001)
The influence of the addition of methanol, ethanol, 1-propanol and 2-propanol to the dispersing medium of a mixture of RuO2 and TiO2 sols on the electrochemically active surface area for proton exchange, as well as on the ...
A time effect in the early stages of a surface oxidation of a Pt(111) plane in alkaline solution / Vremenski efekat u oksidaciji Pt(111) površine u alkalnoj sredini
(Serbian Chemical Society, 2001)
A time effect in the early stages of surface oxidation of a Pt(111) plane in 0.1 M NaOH solution was studied by examining the reduction parts of the j/E profile recorded after holding the potential for various times at ...
The influence of inert component on the morphology and porosity parameters of macroporous poly (4-vinyl pyridine-co-ethylene glycol dimethacrylate) / Uticaj sastava i udela inertne komponente na morfologiju i parametre porozne strukture makroporoznog kopolimera 4-vinilpiridina i etilenglikoldimetakrilata
(Association of Chemical Engineers of Serbia, 2001)
In this study, the influence of the type and content of inert component in the reaction mixture on the properties of crosslinked macroporous copolymers of 4-vinyl pyridine and ethylene glycol dimethacrylate, poly ...
Carbon monoxide oxidation on a Au(111) surface modified by spontaneously deposited Ru / Оксидација CO на Au(111) површини модификованој спонтано депонованим Ru
(Belgrade : Serbian Chemical Society, 2001)
The spontaneous deposition of Ru on Au(111) was performed in 10-3 M RuCl3-0.5 M H2SO4 solution. The obtained surface was characterized by STM under potential control in 0.5 M H2SO4 solution. The coverage of the Au(111) ...
Antena solution for future communication devices in mm-wave range
(Udruženje za mikrotalasnu tehniku i tehnologiju i IEEE MTT-S Chapter-a Srbije, Beograd, 2001)
Different type of printed antennas for millimeter ranges like: high gain (narrow beam) with linear and circular polarization, sector antennas with azimuth angle of 600, 900 and 1800, omnidirectional antennas are proposed. ...
A brief review of microwave photonic band-gap (PGB) structures
(Udruženje za mikrotalasnu tehniku i tehnologiju i IEEE MTT-S Chapter-a Srbije, Beograd, 2001)