Претраживање
Приказ резултата 31-40 од 60
The Effect of Sintering Temperature on Mesoporous Structure of WO3 Doped Tio(2) Powders
(International Institute for the Science of Sintering, Beograd, 2018)
In this study, WO3 doped TiO2 powders were synthesized via sol-gel method combined with a hydrothermal process. The effect of sintering temperature on mesoporous structure and catalytic activities of these powders were ...
The effect of ageing on YBa2Cu3O7-x obtained by the photoacoustic method
(Belgrade: International Institute for the Science of Sintering, 2003)
Thermal diffusivity and electric transport properties of fourteen years old superconducting YBa2Cu3O7-x pellets were obtained using the photoacoustic transmission technique and then compared with freshly made superconducting ...
Anisotropy Analysis of Low Cement Concrete by Ultrasonic Measurements and Image Analysis
(International Institute for the Science of Sintering, Beograd, 2016)
The analized material was high alumina low cement castable sintered at three different temperatures. Influence of initial material anisotropy on the thermal shock resistance as well as changes of anisotropy level during ...
Characterisation of dispersive systems using a coherer
(Belgrade : International Institute for the Science of Sintering, 2002)
The possibility of characterization of aluminium powders using a horizontal coherer has been considered. Al powders of known dimension were treated with a high frequency electromagnetic field or with a DC electric field, ...
Organobentonite: Characterization and Adsorptive Properties towards Phenol and its Derivatives
(International Institute for the Science of Sintering, Beograd, 2016)
Bentonite from Mecji Do locality in Serbia was modified with hexadecyltrimethylammonium bromide (HDTMA-Br), and the sample was denoted as HDTMA-MD. The characterization of the material included X-Ray diffraction, elemental ...
The influence of barium ferrite nanoparticles on morphological and mechanical properties of ethyl cellulose based nanocomposites
(Belgrade : Association for ETRAN Society, 2019)
This study presents preparation and characterization of ethyl cellulose based nanocomposites. Successful use of simple solvent casting technique provided nanocomposites with high loads of barium ferrite magnetic nanopowder ...
The Characterization of Sintered SmCo5 Magnets
(Association for ETRAN Society, 1999)
During the investigation and design of laboratory model of a Sintered SmCo5 magnet, a group of methods for characterizing sintered and heat treated magnets was defined. The direct dependence of the magnetic properties of ...
Structure and Properties of Nanocrystalline Tetragonal BaTiO3 Prepared by Combustion Solid State Synthesis
(International Institute for the Science of Sintering, 2020)
Barium titanate (BaTiO3) attracts high scientific and technological attention due to good dielectric and electromechanical properties. Although BaTiO3 is one of the most frequently investigated ferroelectric materials, the ...
Effect of Sintering Temperature and Calcium amount on Compressive Strength of Brushite-Metakaolin Polymer Materials
(Association for ETRAN Society, 2022)
The effect of Ca2+ amount and sintering temperature on mechanical properties of geopolymer-brushite (GPB) binders was investigated. Brushite and raw abandoned kaolinite clay thermally transformed into metakaolin were used ...
Characterization of cobalt ferrite nanoparticles obtained by various synthesis methods and comparison with the Raman spectra of other ferrites and some cubic oxide spinels / Kарактеризација наночестица кобалт ферита добијених различитим методама синтезе и поређење са Рамановим спектрима других ферита и неких кубичних оксидних спинела
(Association for ETRAN Society, 2023)
ingle phase cobalt ferrite (CoFe2O4) with nanoparticles of similar sizes (15.7-19 nm) was obtained by different synthesis methods: coprecipitation, ultrasonically assisted coprecipitation, coprecipitation followed by ...