Search
Now showing items 1-10 of 17
A possible connection between phosphate tungsten bronzes properties and briggs-rauscher oscillatory reaction response
(Belgrade : International Institute for the Science of Sintering (IISS), 2021)
The calcium phosphate tungsten bronze (Ca-PWB) has been synthesized and characterized (TGA, DSC, XRPD, FTIR, SEM). The influence of solid insoluble materials Ca-PWB, as well as lithium doped (Li-PWB) and cation free phosphate ...
Application of Ni(II)-alumina Composites for Electrocatalytic Reduction of 4-nitrophenol
(International Institute for the Science of Sintering, Belgrade, 2020)
Nickel-alumina composites with various content of nickel were synthetized by sol-gel method. The characterization of samples was performed by diffuse reflectance spectroscopy and electrochemical impedance spectroscopy using ...
Macroporous monoliths based оn natural mineral sources, clay аnd diatomite
(Belgrade : Association for ETRAN Society, 2020)
Macroporous silica ceramic was obtained using clay and diatomite. Boric acid as a low-cost additive in the amount of 1 wt% was used. These porous materials were obtained at low forming pressure (40-80 MPa) and lower sintering ...
The Influence of pH on Electrochemical Behavior of Nicotine- Clay based Electrodes
(Belgrade : International Institute for the Science of Sintering (IISS), 2021)
Montmorillonite based clay was acid activated. Nicotine was adsorbed on untreated
and acid activated clay from its aqueous solution at either pH=6 or pH=9.26 (unadjusted pH
solution). The XRD analysis revealed that the ...
Effect оf delamination оn physico-chemical properties оf kaolin
(International Institute for the Science of Sintering (IISS), 2021)
To provide the quality required for its use, raw kaolin must be subjected to certain processing procedures like delamination which is applied to the layered structure materials. The aim of this research is to determine the ...
Impact of Alumina Particles on the Morphology and Mechanics of Hybrid Wood Plastic Composite Materials
(Belgrade : Association for ETRAN Society, 2019)
Hybrid composite panels of Wood-Plastic Composites (WPC) consisting of wood and
poly (methyl methacrylate) (PMMA) were reinforced with alumina particles and made by
“hot pressing” method. Alumina-based particles were ...
The influence of strontium content and sintering temperature on monazite stability
(Association for ETRAN Society, 2024)
This paper shows a simple way to synthesize a series of Ce1-xSrxPO4 ceramic materials using acetate solutions of Ce and Sr instead of nitrate which were used so far. For synthesis, the preparation method was used by simple ...
The influence of barium ferrite nanoparticles on morphological and mechanical properties of ethyl cellulose based nanocomposites
(Belgrade : Association for ETRAN Society, 2019)
This study presents preparation and characterization of ethyl cellulose based nanocomposites. Successful use of simple solvent casting technique provided nanocomposites with high loads of barium ferrite magnetic nanopowder ...
Multiferroic Heterostructure BaTiO3/ε-Fe2O3 Composite Obtained by in situ Reaction
(Belgrade : International Institute for the Science of Sintering, 2021)
Solid-state reaction between BaTiO3 and Fe2O3 was used to produce a multiferroic heterostructure composite. Commercial BaTiO3 and Fe(NO3)3•9H2O were suspended in ethanol for 30 minutes in an ultrasound bath. The prepared ...
Evaluation of adsorption performance and quantum chemical modeling of pesticides removal using cell-MG hybrid adsorbent
(Belgrade : International Institute for the Science of Sintering (IISS), 2021)
Magnetite (MG) modified cellulose membrane (Cell-MG), obtained by reaction of 3-aminosilane and subsequently with diethylenetriaminepentaacetic acid dianhydride functionalized waste Cell fibers (Cell-NH2 and Cell-DTPA, ...