Претраживање
Приказ резултата 51-60 од 530
Synthesis and characterization of octenyl succinic anhydride modified levan
(10th European Symposium on Biopolymers, Straubing, Germany, September 25-27, 2019, Program Abstracts, 2019)
The aim of the present study is to optimize the synthesis of OSA-levan derivative.
A study of water influence on carbon monoxide adsorption and oxidation on nanocrystals of: γ-Fe2O3, Au/Fe2O 3 and MnxZn1-xFe2O4
(Materials Science Forum, 2006)
In this paper the adsorption and oxidation of CO on nanocrystalline Au/γ-Fe2O3, Au/α-Fe2O3, γ-Fe2O3 and a series of mixed ferrite with Mn xZn1-xFe2O4 composition are investigated. The catalysts were prepared by co-precipitation ...
Preparation of ZrO2 and Al2O3 thin-films on stainless steel by spray pyrolysis
(Research Trends in Contemporary Materials Science, 2007)
We have investigated the deposition of ZrO2 and Al2O3 films on a stainless steel (SS) substrate by spray pyrolysis method. The ZrO2 films were deposited from aqueous solution of zirconium dinitrate oxide. For Al2O3 films, ...
N-type silicon electron mobility and its relationship to the kink effect for nano-scaled SOI NMOS devices
(Materials Science Forum, 2007)
Electron mobility for the silicon-based devices is one of the most important parameters, which determine the behavior of components. Mobility depends on silicon purity, doping level, presence of lattice defects and electric ...
Microstructural properties of PZT thin films deposited on LaNIQ 3-coated substrates
(Materials Science Forum, 2007)
The modified polymeric precursor method (Pechini method) was successfully used for the preparation of epitaxial and polycrystalline ferroelectric Pb(Zr0.52Ti0.48)O3 (PZT) thin films. Films were deposited on LaNiO3 (LNO) - ...
A wireless system for liquid level measurement
(8th International Conference on Telecommunications in Modern Satellite, Cable and Broadcasting Servi, 2007)
A wireless system for liquid level measurement is presented. It is developed in order to meet stringent power consumption requirements, but without sacrificing the accuracy of the built-in pressure sensor. The communication ...
Morphology and phase composition of Ni-Co alloy powders electrodeposited from ammonium sulfate-boric acid electrolyte
(Materials Science Forum, 2006)
In this paper the morphology of Ni-Co powders electrodeposited from ammonium sulfate-boric acid containing electrolyte is investigated as a function of alloy powder composition. Composition of the electrolyte, i.e. the ...
Boron redistribution during SOI wafers thermal oxidation
(Institute of Electrical and Electronics Engineers Inc., 2006)
We fabricated Silicon-On-Insulator (Sol) pressure sensors intended for operation in a wide temperature range. After the thermal oxidation process, the measured sheet resistance of the silicon active layer was higher than ...
Teaching optics: Preuniversity level
(19th Telecommunications Forum, TELFOR 2011 - Proceedings of Papers, 2011)
This paper presents the expirience of introducing the Optics Suitcase, a portable kit for demonstrating optics to students, developed at the Institute of Optics in Rochester, to high school children following experimental ...
Analytical modelling of transient processes in thermal microsensors
(12th Int. Conf. on Thermal, Mechanical and Multi-Physics Simulation and Experiments in Microele, 2011)
An analytical method is developed to determine the frequency response of thermal microsensors on various input actions. The method has the following algorithm. In a microsensor, the domain of modelling is marked out. This ...