Pretraživanje
Prikaz rezultata 1-10 od 18
Problem and Solution of UV–Vis Time-Based Measurements of a Chemical System Involving Gas Product: Application to the Bray–Liebhafsky Oscillatory Reaction
(American Chemical Society (ACS), 2021)
Ultraviolet (UV)–visible (Vis) spectroscopy is widely used in all modern laboratories as a routine method of analysis. The monitoring of chemical reactions in an aqueous solution involving a gas product is a demanding task ...
Novel Magnetic Polymer/bentonite Composite: Characterization and Application for Re(VII) and W(VI) Adsorption
(Belgrade : ETRAN Society, 2021)
A novel magnetic polymer/bentonite composite was prepared by suspension copolymerization of glycidyl methacrylate and ethylene glycol dimethacrylate in the presence of magnetic bentonite (MB-PGME) and functionalized with ...
Preparation and Characterization of Novel Glycidyl Methacrylate/Clay Nanocomposites
(Serbia : International Institute for the Science of Sintering (IISS), 2022)
The impact of the type and amounts of nanofiller on the features of the glycidyl methacrylate-co-ethylene glycol dimethacrylate (GMA-co-EGDMA)/organomodified montmorillonite (OMt) nanocomposites that were prepared by in ...
Optimization of solid-state fermentation for enhanced production of pectinolytic complex by Aspergillus tubingensis FAT43 and its application in fruit juice processing
(Oxford University Press, 2023)
The main goal of this study was to examine the efficiency of a newly isolated fungus from quince, Aspergillus tubingensis FAT43, to produce the pectinolytic complex using agricultural and industrial waste as the substrate ...
Effect of Sintering Temperature and Calcium amount on Compressive Strength of Brushite-Metakaolin Polymer Materials
(Association for ETRAN Society, 2022)
The effect of Ca2+ amount and sintering temperature on mechanical properties of geopolymer-brushite (GPB) binders was investigated. Brushite and raw abandoned kaolinite clay thermally transformed into metakaolin were used ...
Monitoring of a ceramic surface temperature field induced by pulsed Nd: YAG laser
(Vinča Institute of Nuclear Sciences, Belgrade, 2021)
Temperature distribution induced by laser radiation is a very important
parameter for an efficient and safe application of lasers in different ceramic
processing techniques. This paper presents the results ...
Microhardness measurement optimization in green derived silica/polyester composites using response surface methodology
(SAGE, 2024)
Polymer composites based on unsaturated polyester resin (UPR) and reinforced with particles based on unmodified/modified
plant provenance biosilica particles were synthesized and characterized. An unsaturated polyester ...
DNA Sequencing with Single-Stranded DNA Rectification in a Nanogap Gated by N‑Terminated Carbon Nanotube Electrodes
(American Chemical Society (ACS), 2020)
Fast, reliable, and inexpensive DNA sequencing is an important pursuit in healthcare, especially in personalized medicine with possible deep societal impacts. Despite significant progress in various nanopore-based sequencing ...
Fractionation of Potentially Toxic Elements (PTEs) in Urban Soils from Salzburg, Thessaloniki and Belgrade: An Insight into Source Identification and Human Health Risk Assessment
(MDPI, 2021)
Concentrations of potentially toxic elements (PTEs) (Al, As, Cd, Cr, Cu, Ni, Pb, and
Zn) were measured in topsoil samples collected from parks in the cities of Salzburg (Austria),
Thessaloniki (Greece), and Belgrade ...
Influence of alumina addition on structural and catalytic properties of sulphated zirconia in isomerization of n-hexane
(Novi Sad : University of Novi Sad, Faculty of Technology, 2021)
New binary catalytic systems based on sulphated zirconia-alumina were synthesized by controlled hydrolysis of alkoxides using relative molar ratios of constituents 1:1, 1:2 and 1:3 in favour of zirconia. The obtained ...