Претраживање
Приказ резултата 21-30 од 127
Morphology and phase composition of Ni-Co alloy powders electrodeposited from ammonium sulfate-boric acid electrolyte
(Materials Science Forum, 2006)
In this paper the morphology of Ni-Co powders electrodeposited from ammonium sulfate-boric acid containing electrolyte is investigated as a function of alloy powder composition. Composition of the electrolyte, i.e. the ...
Boron redistribution during SOI wafers thermal oxidation
(Institute of Electrical and Electronics Engineers Inc., 2006)
We fabricated Silicon-On-Insulator (Sol) pressure sensors intended for operation in a wide temperature range. After the thermal oxidation process, the measured sheet resistance of the silicon active layer was higher than ...
Scanning probe-shaped nanohole arrays with extraordinary optical transmission as platform for enhanced surface plasmon-based biosensing
(Institute of Electrical and Electronics Engineers Inc., 2006)
We analyzed the use of subwaveleneth ordered nanohole patterns for detection of miniscule amounts of biological analytes. Owing to their surface plasmon resonance (SPR) operation, such structures show an extraordinarily, ...
Adsorbed mass fluctuations of a micro/nanoresonator surrounded by an arbitrary gas mixture
(Institute of Electrical and Electronics Engineers Inc., 2006)
Micro/nanoresonator mass and frequency fluctuations caused by sorption processes on a resonator surface are investigated. Arbitrary gas mixture is considered. assuming that particle arrivals at the surface are all poissonian ...
Silicon surface exfoliation under compression plasma flow action
(25th International Conference on Microelectronics, MIEL 2006 - Proceedings, 2006)
Silicon single crystal surfaces have been modified by supersonic compression plasma flows (CPF) action. Triangular and rhombic regular fracture features are obtained on the Si (111), while rectangular ones are produced on ...
Mechanically activated synthesis of CaTiO3 from mixture of CaO and TiO2
(Materials Science Forum, 2005)
Crystalline calcium titanate was synthesized by mechanical activation of a mixture of CaO, obtained by thermal treatment of CaCO3, and TiO 2 in anatase or rutile form, in a planetary ball mill for 30, 60, 120 and 240 min.. ...
IR bimaterial detectors performance
(Institute of Electrical and Electronics Engineers Inc., 2006)
In this paper basic parameters of a bimaterial infrared thermal detector (BMD) - sensitivity, noise equivalent power, detectivity - and their dependence on relevant thermal and mechanical parameters are given. In order to ...
Chemical and radiochemical characterization of depleted uranium in contaminated soils
(Maik Nauka/Interperiodica/Springer, New York, 2007)
The main results of chemical and radiochemical characterization and fractionation of depleted uranium in soils contaminated during the Balkan conflict in 1999 are presented in the paper. Alpha-spectrometric analysis of ...
Adsorption-Desorption Noise in Plasmonic Chemical/Biological Sensors in Multiple Analyte Environment
(Smart Sensors, Actuators, and Mems Iv, 2009)
We analyzed the intrinsic noise of plasmonic sensors caused by the adsorption-desorption of gaseous analytes on the sensor surface. We analyzed a general situation when there is a larger number of different species in the ...
Analyse of One Type of Resonant Cell
(9th International Conference on Telecommunications in Modern Satellite, Cable, and Broadcasting Serv, 2009)
Analyse of one type of resonant cell is proposed. One to three cells are combined into a low pass filter. The filter design curves for various substrates and cut off frequencies are presented.