Differences in the electrochemical behavior of ruthenium and iridium oxide in electrocatalytic coatings of activated titanium anodes prepared by the sol-gel procedure
Razlike u elektrohemijskom ponašanju oksida rutenijuma i iridijuma u elektrokatalitičkim prevlakama aktiviranih titanskih anoda dobijenih sol-gel postupkom

2010
Аутори
Panić, Vladimir
Dekanski, Aleksandar

Mišković-Stanković, Vesna

Milonjić, Slobodan K.

Nikolic, Branislav Z.
Чланак у часопису (Објављена верзија)
Метаподаци
Приказ свих података о документуАпстракт
The electrochemical characteristics of Ti0.6Ir0.4O2/Ti and Ti0.6Ru0.4O2/Ti anodes prepared by the sol-gel procedure from the corresponding oxide sols, obtained by force hydrolysis of the corresponding metal chlorides, were compared. The voltammetric properties in H2SO4 solution indicate that Ti0.6Ir0.4O2/Ti has more pronounced pseudocapacitive characteristics, caused by proton-assisted, solid state surface redox transitions of the oxide. At potentials negative to 0.0 VSCE, this electrode is of poor conductivity and activity, while the voltammetric behavior of the Ti0.6Ru0.4O2/Ti electrode is governed by proton injection/ejection into the oxide structure. The Ti0.6Ir0.4O2/Ti electrode had a higher electrocatalytical activity for oxygen evolution, while the investigated anodes were of similar activity for chlorine evolution. The potential dependence of the impedance characteristics showed that the Ti0.6Ru0.4O2/ /Ti electrode behaved like a capacitor over a wider potential range than the ...Ti0.6Ir0.4O2/Ti electrode, with fully-developed pseudocapacitive properties at potentials positive to 0.60 VSCE. However, the impedance characteristics of the Ti0.6Ir0.4O2/Ti electrode changed with increasing potential from resistor-like to capacitor-like behavior.
U radu su ispitivane elektrohemijske karakteristike Ti0,6Ir0,4O2/Ti i Ti0,6Ru0,4O2/Ti anoda dobijenih sol-gel postupkom iz oksidnih solova sintetisanih forsiranom hidrolizom odgovarajućih hlorida metala. Voltametrijske karakteristike u rastvoru H2SO4 ukazuju na više izraženo pseudokapacitivno ponašanje Ti0,6Ir0,4O2/Ti elektrode koje je posledica površinskih redoks prelaza u čvrstom stanju uz učešće protona. Na potencijalima negativnijim od 0,0 VZKE ova elektroda pokazuje slabu provodnost i aktivnost, dok voltametrijskim ponašanjem Ti0,6Ru0,4O2/Ti elektrode dominira prodor protona u strukturu oksida. Ti0,6Ir0,4O2/Ti anoda je elektrokatalitički aktivnija za reakciju izdvajanja kiseonika, dok su anode sličnih aktivnosti za reakciju izdvajanja hlora. Impedansne karakteristike formiranih anoda pokazuju da se Ti0,6Ru0,4O2/Ti elektroda ponaša slično kondenzatoru u širem opsegu potencijala nego što je to slučaj sa Ti0,6Ir0,4O2/Ti elektrodom, sa potpuno razvijenim pseudokapacitivnim svojstvima ...na potencijalima pozitivnijim od 0,60 VZKE. S druge strane, za Ti0,6Ir0,4O2/Ti elektrodu se uočava prelaz sa karakteristika sličnih otporniku na karakteristike slične kondenzatoru sa porastom potencijala elektrode.
Кључне речи:
activated titanium anodes / sol-gel procedure / ruthenium and iridium oxide / electrochemical impedance spectroscopy / pseudocapacitanceИзвор:
Journal of the Serbian Chemical Society, 2010, 75, 10, 1413-1420Издавач:
- Serbian Chemical Society
Финансирање / пројекти:
- Композитни материјали на бази угљеника, метала и оксида метала у електрокатализи и процесима складиштења енергије (RS-142048)
- Развој нових и побољшање постојећих спектроскопских и електроаналитичких метода за праћење стања животне средине (RS-142060)
DOI: 10.2298/JSC100310078P
ISSN: 0352-5139
WoS: 000283895200010
Scopus: 2-s2.0-78449281544
Институција/група
IHTMTY - JOUR AU - Panić, Vladimir AU - Dekanski, Aleksandar AU - Mišković-Stanković, Vesna AU - Milonjić, Slobodan K. AU - Nikolic, Branislav Z. PY - 2010 UR - https://cer.ihtm.bg.ac.rs/handle/123456789/676 AB - The electrochemical characteristics of Ti0.6Ir0.4O2/Ti and Ti0.6Ru0.4O2/Ti anodes prepared by the sol-gel procedure from the corresponding oxide sols, obtained by force hydrolysis of the corresponding metal chlorides, were compared. The voltammetric properties in H2SO4 solution indicate that Ti0.6Ir0.4O2/Ti has more pronounced pseudocapacitive characteristics, caused by proton-assisted, solid state surface redox transitions of the oxide. At potentials negative to 0.0 VSCE, this electrode is of poor conductivity and activity, while the voltammetric behavior of the Ti0.6Ru0.4O2/Ti electrode is governed by proton injection/ejection into the oxide structure. The Ti0.6Ir0.4O2/Ti electrode had a higher electrocatalytical activity for oxygen evolution, while the investigated anodes were of similar activity for chlorine evolution. The potential dependence of the impedance characteristics showed that the Ti0.6Ru0.4O2/ /Ti electrode behaved like a capacitor over a wider potential range than the Ti0.6Ir0.4O2/Ti electrode, with fully-developed pseudocapacitive properties at potentials positive to 0.60 VSCE. However, the impedance characteristics of the Ti0.6Ir0.4O2/Ti electrode changed with increasing potential from resistor-like to capacitor-like behavior. AB - U radu su ispitivane elektrohemijske karakteristike Ti0,6Ir0,4O2/Ti i Ti0,6Ru0,4O2/Ti anoda dobijenih sol-gel postupkom iz oksidnih solova sintetisanih forsiranom hidrolizom odgovarajućih hlorida metala. Voltametrijske karakteristike u rastvoru H2SO4 ukazuju na više izraženo pseudokapacitivno ponašanje Ti0,6Ir0,4O2/Ti elektrode koje je posledica površinskih redoks prelaza u čvrstom stanju uz učešće protona. Na potencijalima negativnijim od 0,0 VZKE ova elektroda pokazuje slabu provodnost i aktivnost, dok voltametrijskim ponašanjem Ti0,6Ru0,4O2/Ti elektrode dominira prodor protona u strukturu oksida. Ti0,6Ir0,4O2/Ti anoda je elektrokatalitički aktivnija za reakciju izdvajanja kiseonika, dok su anode sličnih aktivnosti za reakciju izdvajanja hlora. Impedansne karakteristike formiranih anoda pokazuju da se Ti0,6Ru0,4O2/Ti elektroda ponaša slično kondenzatoru u širem opsegu potencijala nego što je to slučaj sa Ti0,6Ir0,4O2/Ti elektrodom, sa potpuno razvijenim pseudokapacitivnim svojstvima na potencijalima pozitivnijim od 0,60 VZKE. S druge strane, za Ti0,6Ir0,4O2/Ti elektrodu se uočava prelaz sa karakteristika sličnih otporniku na karakteristike slične kondenzatoru sa porastom potencijala elektrode. PB - Serbian Chemical Society T2 - Journal of the Serbian Chemical Society T1 - Differences in the electrochemical behavior of ruthenium and iridium oxide in electrocatalytic coatings of activated titanium anodes prepared by the sol-gel procedure T1 - Razlike u elektrohemijskom ponašanju oksida rutenijuma i iridijuma u elektrokatalitičkim prevlakama aktiviranih titanskih anoda dobijenih sol-gel postupkom VL - 75 IS - 10 SP - 1413 EP - 1420 DO - 10.2298/JSC100310078P ER -
@article{ author = "Panić, Vladimir and Dekanski, Aleksandar and Mišković-Stanković, Vesna and Milonjić, Slobodan K. and Nikolic, Branislav Z.", year = "2010", abstract = "The electrochemical characteristics of Ti0.6Ir0.4O2/Ti and Ti0.6Ru0.4O2/Ti anodes prepared by the sol-gel procedure from the corresponding oxide sols, obtained by force hydrolysis of the corresponding metal chlorides, were compared. The voltammetric properties in H2SO4 solution indicate that Ti0.6Ir0.4O2/Ti has more pronounced pseudocapacitive characteristics, caused by proton-assisted, solid state surface redox transitions of the oxide. At potentials negative to 0.0 VSCE, this electrode is of poor conductivity and activity, while the voltammetric behavior of the Ti0.6Ru0.4O2/Ti electrode is governed by proton injection/ejection into the oxide structure. The Ti0.6Ir0.4O2/Ti electrode had a higher electrocatalytical activity for oxygen evolution, while the investigated anodes were of similar activity for chlorine evolution. The potential dependence of the impedance characteristics showed that the Ti0.6Ru0.4O2/ /Ti electrode behaved like a capacitor over a wider potential range than the Ti0.6Ir0.4O2/Ti electrode, with fully-developed pseudocapacitive properties at potentials positive to 0.60 VSCE. However, the impedance characteristics of the Ti0.6Ir0.4O2/Ti electrode changed with increasing potential from resistor-like to capacitor-like behavior., U radu su ispitivane elektrohemijske karakteristike Ti0,6Ir0,4O2/Ti i Ti0,6Ru0,4O2/Ti anoda dobijenih sol-gel postupkom iz oksidnih solova sintetisanih forsiranom hidrolizom odgovarajućih hlorida metala. Voltametrijske karakteristike u rastvoru H2SO4 ukazuju na više izraženo pseudokapacitivno ponašanje Ti0,6Ir0,4O2/Ti elektrode koje je posledica površinskih redoks prelaza u čvrstom stanju uz učešće protona. Na potencijalima negativnijim od 0,0 VZKE ova elektroda pokazuje slabu provodnost i aktivnost, dok voltametrijskim ponašanjem Ti0,6Ru0,4O2/Ti elektrode dominira prodor protona u strukturu oksida. Ti0,6Ir0,4O2/Ti anoda je elektrokatalitički aktivnija za reakciju izdvajanja kiseonika, dok su anode sličnih aktivnosti za reakciju izdvajanja hlora. Impedansne karakteristike formiranih anoda pokazuju da se Ti0,6Ru0,4O2/Ti elektroda ponaša slično kondenzatoru u širem opsegu potencijala nego što je to slučaj sa Ti0,6Ir0,4O2/Ti elektrodom, sa potpuno razvijenim pseudokapacitivnim svojstvima na potencijalima pozitivnijim od 0,60 VZKE. S druge strane, za Ti0,6Ir0,4O2/Ti elektrodu se uočava prelaz sa karakteristika sličnih otporniku na karakteristike slične kondenzatoru sa porastom potencijala elektrode.", publisher = "Serbian Chemical Society", journal = "Journal of the Serbian Chemical Society", title = "Differences in the electrochemical behavior of ruthenium and iridium oxide in electrocatalytic coatings of activated titanium anodes prepared by the sol-gel procedure, Razlike u elektrohemijskom ponašanju oksida rutenijuma i iridijuma u elektrokatalitičkim prevlakama aktiviranih titanskih anoda dobijenih sol-gel postupkom", volume = "75", number = "10", pages = "1413-1420", doi = "10.2298/JSC100310078P" }
Panić, V., Dekanski, A., Mišković-Stanković, V., Milonjić, S. K.,& Nikolic, B. Z.. (2010). Differences in the electrochemical behavior of ruthenium and iridium oxide in electrocatalytic coatings of activated titanium anodes prepared by the sol-gel procedure. in Journal of the Serbian Chemical Society Serbian Chemical Society., 75(10), 1413-1420. https://doi.org/10.2298/JSC100310078P
Panić V, Dekanski A, Mišković-Stanković V, Milonjić SK, Nikolic BZ. Differences in the electrochemical behavior of ruthenium and iridium oxide in electrocatalytic coatings of activated titanium anodes prepared by the sol-gel procedure. in Journal of the Serbian Chemical Society. 2010;75(10):1413-1420. doi:10.2298/JSC100310078P .
Panić, Vladimir, Dekanski, Aleksandar, Mišković-Stanković, Vesna, Milonjić, Slobodan K., Nikolic, Branislav Z., "Differences in the electrochemical behavior of ruthenium and iridium oxide in electrocatalytic coatings of activated titanium anodes prepared by the sol-gel procedure" in Journal of the Serbian Chemical Society, 75, no. 10 (2010):1413-1420, https://doi.org/10.2298/JSC100310078P . .