Претраживање
Приказ резултата 1-10 од 24
Macroporous monoliths based оn natural mineral sources, clay аnd diatomite
(Belgrade : Association for ETRAN Society, 2020)
Macroporous silica ceramic was obtained using clay and diatomite. Boric acid as a low-cost additive in the amount of 1 wt% was used. These porous materials were obtained at low forming pressure (40-80 MPa) and lower sintering ...
Effect оf delamination оn physico-chemical properties оf kaolin
(International Institute for the Science of Sintering (IISS), 2021)
To provide the quality required for its use, raw kaolin must be subjected to certain processing procedures like delamination which is applied to the layered structure materials. The aim of this research is to determine the ...
The Influence of pH on Electrochemical Behavior of Nicotine- Clay based Electrodes
(Belgrade : International Institute for the Science of Sintering (IISS), 2021)
Montmorillonite based clay was acid activated. Nicotine was adsorbed on untreated
and acid activated clay from its aqueous solution at either pH=6 or pH=9.26 (unadjusted pH
solution). The XRD analysis revealed that the ...
The influence of strontium content and sintering temperature on monazite stability
(Association for ETRAN Society, 2024)
This paper shows a simple way to synthesize a series of Ce1-xSrxPO4 ceramic materials using acetate solutions of Ce and Sr instead of nitrate which were used so far. For synthesis, the preparation method was used by simple ...
Mechanical Properties of Biomass-derived Silica Nanoparticles Reinforced PMMA Composite Material
(Science of Sintering, 2022)
Rice husk was used to produce silica particles, which were then used to reinforce the polymer matrix. The synthesized SiO2 particles were characterized using X-ray diffraction, Fourier transforms infrared spectroscopy ...
Oxide Powder Mixture with Poly-vinyl Alcohol (PVA) and added Polyethylene Glycol (PEG) as Plasticizer
(Belgrade : Association for ETRAN Society, 2023)
Powder mixture consisted of ZnO, Mn2O3 (MnCO3) and Fe2O3 blended powders, was found laminating during compaction. Polyvinyl alcohol (PVA) and a combination of PVA with polyethylene glycol (PEG) added as a plasticizer, were ...
Deterioration Characterization during Thermal Shock Testing
(International Institute for the Science of Sintering (IISS), 2023)
Thermal shock stability plays a great role in the selection of optimal refractory material. Different methods of characterization were developed for this purpose, including the implementation of nondestructive testing. ...
The influence of strontium content and sintering temperature on monazite stability
(Association for ETRAN Society, 2023)
This paper shows a simple way to synthesize a series of Ce1-xSrxPO4 ceramic materials using acetate solutions of Ce and Sr instead of nitrate which were used so far. For synthesis, the preparation method was used by simple ...
Effect of Sintering Temperature and Calcium amount on Compressive Strength of Brushite-Metakaolin Polymer Materials
(Association for ETRAN Society, 2022)
The effect of Ca2+ amount and sintering temperature on mechanical properties of geopolymer-brushite (GPB) binders was investigated. Brushite and raw abandoned kaolinite clay thermally transformed into metakaolin were used ...
Characterization of cobalt ferrite nanoparticles obtained by various synthesis methods and comparison with the Raman spectra of other ferrites and some cubic oxide spinels / Kарактеризација наночестица кобалт ферита добијених различитим методама синтезе и поређење са Рамановим спектрима других ферита и неких кубичних оксидних спинела
(Association for ETRAN Society, 2023)
ingle phase cobalt ferrite (CoFe2O4) with nanoparticles of similar sizes (15.7-19 nm) was obtained by different synthesis methods: coprecipitation, ultrasonically assisted coprecipitation, coprecipitation followed by ...