Претраживање
Приказ резултата 1-10 од 10
Comparison of open porous copper structures obtained by the different current regimes of electrolysis
(Elsevier, 2012)
Formation of open porous copper structures by the electrodeposition processes in the hydrogen code-position range was considered. Morphologies of copper deposits obtained by the reversing current (RC) regimes at the same ...
A Novel Route for Electrolytic Production of Very Branchy Copper Dendrites under Extreme Conditions
(IOP Publishing Limited, 2021)
Copper electrodeposition in a form of powder was examined using the pulsating overpotential (PO) regime from the sulfate electrolyte without or with an addition of various concentrations of chloride ions. Morphological and ...
Electrodeposition of Ni, Co and Ni–Co alloy powders
(Elsevier, 2006)
In this paper the polarization characteristics of the processes of Ni and Co powders and Ni-Co alloy powders electrodeposition from ammonium sulfate containing supporting electrolyte are investigated as a function of Ni ...
A Novel Route for Electrolytic Production of Very Branchy Copper Dendrites under Extreme Conditions
(IOP Publishing Limited, 2021)
Copper electrodeposition in a form of powder was examined using the pulsating overpotential (PO) regime from the sulfate electrolyte without or with an addition of various concentrations of chloride ions. Morphological and ...
Influence of the complex formation on the morphology of lead powder particles produced by the electrodeposition processes
(Elsevier, 2013)
The processes of lead electrodeposition from the basic (nitrate) and complex (acetate) electrolytes were mutually compared by the analysis of their polarization characteristics and by the scanning electron microscopic (SEM) ...
Effect of parameters of square-wave pulsating current on copper electrodeposition in the hydrogen co-deposition range
(Elsevier Science Inc, New York, 2010)
Copper electrodeposition processes in the hydrogen co-deposition range by the pulsating current (PC) regime were examined by the determination of the average current efficiency of hydrogen evolution and by the scanning ...
Effect of parameters of pulsating current (PC) regimes on morphology of electrodeposited copper in hydrogen co-deposition range
(Serbian Chemical Society, Belgrade, 2010)
The most often employed electrolytes for the electrodeposition of copper are those based on aqueous solutions of sulfuric acid (H2SO4) and cupric sulfate (CuSO4). There is an ionic equilibrium of a lot of species in the ...
Optimization of process of the honeycomb-like structure formation by the regime of reversing current (RC) in the second range
(Springer-Verlag, 2020)
Formation of the honeycomb-like electrodes of copper by the regime of reversing current (RC) in the second range has been
investigated. Morphological and structural characteristics of this electrode type obtained by various ...
Structural, Mechanical and Electrical Characteristics of Copper Coatings Obtained by Various Electrodeposition Processes
(MDPI, 2022)
Mechanical (hardness and adhesion) and electrical (sheet resistance) characteristics of electrolytically produced copper coatings have been investigated. Morphologies of Cu coatings produced galvanostatically at two current ...
Morphology and composition of Ni-Co electrodeposited powders
(Elsevier Science Inc, New York, 2011)
The morphology, phase and chemical composition of Ni-Co alloy powders electrodeposited from an ammonium sulfate-boric acid containing electrolyte with different ratio of Ni/Co ions were investigated. The ratios of NVCo ...