Претраживање
Приказ резултата 11-17 од 17
Corrosion stability of Zn-Co alloys deposited from baths with high and low Co content - The influence of deposition current density
(Elsevier, 2010)
Electrochemically deposited Zn-Co alloys under various deposition conditions were investigated using atomic absorption spectroscopy (AAS) for determination of chemical composition, anodic linear sweep voltammetry (ALSV) ...
MgO/ZnO coatings formed on magnesium alloy AZ31 by plasma electrolytic oxidation: Structural, photoluminescence and photocatalytic investigation
(Elsevier, 2017)
This paper presents the results of our recent investigation of MgO/ZnO coatings formed on AZ31 magnesium alloy by plasma electrolytic oxidation in phosphate-based alkaline electrolyte with varying concentration of ZnO ...
Effect of Tb3+ doping on the photocatalytic activity of TiO2 coatings formed by plasma electrolytic oxidation of titanium
(Elsevier, 2018)
Tb doped TiO2 coatings are formed by plasma electrolytic oxidation (PEO) of titanium in water solution of 10 g/L Na3PO4.12H(2)O with addition of Tb4O7 powder. Surface morphology, chemical, and phase composition of obtained ...
The influence of anion type in electrolyte on the properties of electrodeposited Zn-Mn alloy coatings
(Elsevier, 2013)
Zn - Mn alloy electrodeposition on steel electrode, in electrolytes containing chloride or sulfate anions, was investigated by chronopotentiometry. Galvanostatically obtained electrodeposits were characterized by X-ray ...
Anaphoretical/oxidative approach to the in-situ synthesis of adherent hydroxyapatite/titanium oxide composite coatings on titanium
(Elsevier, 2019)
In-situ synthesis of HAp/TiO2 coating on titanium was performed via anaphoretic deposition of HAp and simultaneous anodization of Ti to produce highly adherent and strengthened composite coating. The prepared coatings were ...
Corrosion study of ceria coatings on AA6060 aluminum alloy obtained by cathodic electrodeposition: Effect of deposition potential
(Elsevier, 2014)
Among potential replacements for chromates, cerium-based conversion coatings (CeCCs) have been identified as leading candidates, showing a good promise as environmentally compliant corrosion inhibitors on Al alloys. In ...
TiO2/WO3 photocatalytic composite coatings prepared by spray pyrolysis
(Elsevier, 2014)
TiO2/WO3 composites supported on a stainless steel foil were prepared by the spray pyrolysis technique. Content of WO3 was gradually increased from 1 wt% to 100 wt.%, while the coating thickness was limited to about 1 pm. ...