Претраживање
Приказ резултата 1-10 од 19
Process modelling and analysis of plasma electrolytic oxidation of titanium for TiO2/WO3 thin film photocatalysts by response surface methodology
(Elsevier, 2015)
Plasma electrolytic oxidation of titanium in 12-tungstosilicic acid solution was investigated as a model reaction. The influence of the process parameters (concentration of 12-tungstosilicic acid solution, current density, ...
Morphologies of copper deposits obtained by the electrodeposition at high overpotentials
(Elsevier, 2006)
Morphologies of copper deposits obtained at overpotentials belonging to the plateau of the limiting diffusion current density and at higher
overpotentials were examined by the scanning electron microscopy (SEM) technique. ...
Surface modification of polyethylene by Ag+ and Au+ ion implantation observed by phase imaging atomic force microscopy
(Elsevier, 2012)
High density polyethylene (HDPE) has been modified by Ag+ and Au+ ion implantation with the energy of 60 and 200 keV, respectively. The doses of implanted silver and gold ions were as follows: 1 x 10(15), 5 x 10(15) and 1 ...
Comparative reflection and structural analyses of copper and zinc coatings electrodeposited from acid sulfate solutions without and with additives
(Elsevier, 2002)
Reflection and structural analyses of different copper and zinc coatings were performed. The coatings of copper obtained were from acid sulfate solutions in the absence and presence of thiourea. The coatings of zinc were ...
The properties of electroactive ruthenium oxide coatings supported by titanium-based ternary carbides
(Elsevier, 2007)
Electroactive oxide coatings on titanium, known in industrial chlorine production as dimensionally stable anodes (DSA), are of limited service life owing to the dissolution of active oxide, but also due to low corrosion ...
Antimicrobial viscose fabric prepared by treatment in DBD and subsequent deposition of silver and copper ions-Investigation of plasma aging effect
(Elsevier, 2013)
In this work, the effect of dielectric barrier discharge (DBD) in ambient air on preparation of antimicrobial viscose fabric was studied. DBD plasma treatment was applied under constant discharge power and different exposure ...
Synthesis and characterization of Al2O3/ZnO coatings formed by plasma electrolytic oxidation
(Elsevier, 2015)
Mixed Al2O3/ZnO coatings are prepared by conventional DC plasma electrolytic oxidation (PEO) of aluminum in boric acid and borax solution containing ZnO nanoparticles. Scanning electron microscopy equipped with energy ...
Deposition of silver ions onto DBD and DCSBD plasma treated nonwoven polypropylene
(Elsevier, 2012)
The aim of this work is plasma activation of nonwoven polypropylene (PP) using two different ambient air plasma sources: volume dielectric barrier discharge (DBD) and diffuse coplanar surface barrier discharge (DCSBD) and ...
CdS particles modified TiO2 coatings formed by plasma electrolytic oxidation with enhanced photocatalytic activity
(Elsevier, 2018)
CdS particles modified anatase TiO2 photocatalysts were formed on titanium substrate by plasma electrolytic oxidation for 2 min in supporting electrolyte (10 g/L Na-3 center dot PO4 center dot 12H(2)O) with addition of CdS ...
Corrosion stability of Zn-Co alloys deposited from baths with high and low Co content - The influence of deposition current density
(Elsevier, 2010)
Electrochemically deposited Zn-Co alloys under various deposition conditions were investigated using atomic absorption spectroscopy (AAS) for determination of chemical composition, anodic linear sweep voltammetry (ALSV) ...