Претраживање
Приказ резултата 1-10 од 40
Anodic deposition of colloidal gold
(Elsevier, 1984)
Colloidal gold solutions were prepared following classical recipes. When electrolysed between graphite electrodes, gold was found to deposit at the anode. The rate of deposition was dependent on the anode potential, on the ...
Comparison of open porous copper structures obtained by the different current regimes of electrolysis
(Elsevier, 2012)
Formation of open porous copper structures by the electrodeposition processes in the hydrogen code-position range was considered. Morphologies of copper deposits obtained by the reversing current (RC) regimes at the same ...
Fundamental aspects of pulsating current metal electrodeposition VIII: The effect of pause-to-pulse ratio on microthrowing power of metal deposition
(Elsevier, 1984)
The effect of a pulsating current on the microthrowing power of metal deposits in the early stage of deposition was investigated by scanning electron microscopy. It is shown that at the same average current density the ...
A Novel Route for Electrolytic Production of Very Branchy Copper Dendrites under Extreme Conditions
(IOP Publishing Limited, 2021)
Copper electrodeposition in a form of powder was examined using the pulsating overpotential (PO) regime from the sulfate electrolyte without or with an addition of various concentrations of chloride ions. Morphological and ...
Influence of the complex formation on the morphology of lead powder particles produced by the electrodeposition processes
(Elsevier, 2013)
The processes of lead electrodeposition from the basic (nitrate) and complex (acetate) electrolytes were mutually compared by the analysis of their polarization characteristics and by the scanning electron microscopic (SEM) ...
Fundamental aspects of pulsating current metal electrodeposition IX: The prevention of spongy deposit formation on inert substrates
(Elsevier, 1984)
It is shown that spongy deposits are obtained under d.c. conditions and that compact deposits are obtained in pulsating current (PC) deposition with high pause-to-pulse ratios at the same average current density and ...
A new insight into the mechanism of lead electrodeposition: Ohmic-diffusion control of the electrodeposition process
(Elsevier, 2013)
A new insight into the mechanism of lead electrodeposition from nitrate solutions is presented by analysis of the polarization characteristics and by scanning electron microscopic (SEM) analysis of the surface morphology ...
Application of the general theory of disperse deposits formation in an investigation of mechanism of zinc electrodeposition from the alkaline electrolytes
(Elsevier, 2017)
In this study, mechanism of electrodeposition of zinc from the alkaline electrolytes has been investigated using the general theory of disperse deposits formation. The exchange current densities in the range 18.4-88 mA ...
Aluminium electrodeposition under novel conditions from AlCl3–urea deep eutectic solvent at room temperature
(Elsevier, 2020)
The electrodeposition of aluminium on glassy carbon and aluminium substrates from AlCl3–urea deep eutectic solvent (DES) system at near room temperatures was investigated, without additional purification of the chemicals ...
Electrodeposition of Ni, Co and Ni–Co alloy powders
(Elsevier, 2006)
In this paper the polarization characteristics of the processes of Ni and Co powders and Ni-Co alloy powders electrodeposition from ammonium sulfate containing supporting electrolyte are investigated as a function of Ni ...