Претраживање
Приказ резултата 21-30 од 56
Thermal diffusivity of single crystal Bi0.9Sb0.1
(International Institute for the Science of Sintering, Beograd, 2010)
A single crystal Bi0.9Sb0.1 ingot was synthesized using the Bridgman technique. Thermal diffusivity and electronic transport properties of single crystal cleaved plates (00l) were determined from PA photoacoustic phase and ...
Effect оf delamination оn physico-chemical properties оf kaolin
(International Institute for the Science of Sintering (IISS), 2021)
To provide the quality required for its use, raw kaolin must be subjected to certain processing procedures like delamination which is applied to the layered structure materials. The aim of this research is to determine the ...
Synthesis of Highly Porous Al2O3-YAG Composite Ceramics
(International Institute for the Science of Sintering, Beograd, 2016)
Al2O3-YAG composite was obtained by sintering of porous Al2O3 preforms infiltrated with water solution of aluminium nitrate nonahydrate, Al(NO3)(3)center dot 9H(2)O and yttrium nitrate hexahydrate, Y(NO3)(3)center dot ...
Investigation of the conditions of synthesis composite optical fiber-magnetic powder
(Sintering Society, 2000)
The goal of these investigations was synthesis of composite optical fiber-magnetic powder with new application possibilities like sensors, detectors etc. The part of results of investigation of the possibility of embedding ...
ZnTiO3 ceramic nanopowder microstructure changes during compaction
(International Institute for the Science of Sintering, Beograd, 2013)
ZnTiO3 nanopowder as a constitutive component in compact production was primarily characterized. Scanning electron micrographs of as received powder were recorded. Mercury porosimetry and nitrogen adsorption were also ...
State of the Art and Challenges in Development of Electrical Contact Materials in the Light of the RoHS Directive
(International Institute for the Science of Sintering, Beograd, 2012)
The article surveys current state of the art and challenges in the development of the electrical contact materials in the light of the EU Directive on Restriction of Hazardous Substances (RoHS). The focus was placed on ...
Methanol electrooxidation on PtRu modified zeolite X
(International Institute for the Science of Sintering, Beograd, 2013)
Zeolite NaX (faujasite type) was used as a support for platinum-ruthenium catalyst. A procedure for thermal decomposition of noble metal acetylacetonates to deposit noble metal clusters on the surface of solid support was ...
Cyclic Voltammetric Study of the Influence of Porosity on Electrochemical Response of Nickel-Alumina Modified Glassy Carbon Electrode
(International Institute for the Science of Sintering, Beograd, 2018)
Pure and nickel-modified alumina powders with different porosity were synthesized and applied on the glassy carbon electrode by means of Nafion polymer. The data obtained from the nitrogen adsorption-desorption isotherm ...
Two Step Sintering of ZnTiO3 nanopowder
(International Institute for the Science of Sintering, Beograd, 2017)
Metastable nanopowder ZnTiO3 was pressed into cylindrical compacts at 200 MPa. Compacts were treated by conventional heating with isothermal holding at 931 degrees C for 10 minutes, 25 minutes and 40 minutes. ZnTiO3 compacts ...
Formation of Magnetic Microstructure of the Nanosized NiFe2O4 Synthesized Via Solid-State Reaction
(International Institute for the Science of Sintering, Beograd, 2012)
Magnetic NiFe2O4 structure formation was studied through structural, compositional and magnetic characterization of obtained reaction products of a simple, high yielding and low-cost solid-state reaction. Initial annealing ...