Microbial Recovery of Copper and Zinc from Wasted Electronic Parts
Аутори
Joksimović, KristinaAvdalović, Jelena
Zildžović, S.
Dojčinović, Biljana
Milić, Jelena
Lugonja, Nikoleta
Beškoski, Vladimir
Конференцијски прилог (Објављена верзија)
Метаподаци
Приказ свих података о документуАпстракт
Recycling of electronic waste is crucial not only from the viewpoint of waste treatment but also from aspect of the recovery of valuable metals [1]. The aim of our study was to investigate the potential of using the Acidithiobacillus sp. B2, to solubilize metals (Cu and Zn) from electronic waste. Methodology: Chemical analysis of electronic waste and pyrite The electronic waste (after separating of the plastic parts) and pyrite were pulverized and sieved through a 63 µm stainless steel sieve in preparation for chemical and leaching studies. Electronic waste preparation for the leaching experiment The presence of alkali components in electronic waste is considered inconvenient for the reaction between the electronic waste and the acidic iron(III) sulphate solution. Hence, it is necessary to neutralize the electronic waste before adding the bacterial culture which would generate the oxidant. Before the leaching experiment, electronic waste was dispersed in 0.05 M H2 SO4 solution, shaken... for 48 h, filtered from the solution, washed out with deionized water and dried at 110 °C [2]. Preparation of pyrite for the leaching experiments The pyrite concentrate for the leaching experiments was prepared by treating with a 0.5 mol/dm3 sulphuric acid solution (pH ~ 0.5) (solid to liquid phase ratio 1:5 m/V), and mixing with a mechanical stirrer at a room temperature overnight. Then, the solution was decanted, washed with deionized water and dried at 80 °C to a constant mass [2]. Leaching experiments The leaching experiments were carried out with bacterium Acidithiobacillus sp. B2. Experimental conditions were: leaching period of 20 d, 50 ml leaching solution (g/dm3 ): (NH4 )2 SO4 (3), K2 HPO4 (0.5), MgSO4 x 7H2 O(0.5), KCl (0.1), Ca(NO3 )2 (0.01), at a pH of 2.5 in 150 mL Erlenmeyer flasks at a pulp density of 10% (m/V) (5 g leaching substrate in 50 ml solution). The pH of the leaching solution was maintained at a constant value during the leaching process. One half of the substrate was pyrite and the other was an electronic waste. The initial number of microogranisms was 107 per mL, determined by the Most Probable Number method. The control suspension had the same chemical content and pH value as the suspension with Acidithiobacillus sp. B2 but the Acidithiobacillus sp. B2 culture had been inactivated by sterilization. The study was realized on a horizontal shaker. The incubation temperature was 28 °C [2]. Results and conclusions: The results of the effective metal leaching (calculated by subtraction of percentage metal leaching in the control suspension from that in the Acidithiobacillus sp. B2 suspension) are as follows: Zn (38%)>Cu (35%). The obtained results demonstrate that Acidithiobacillus sp. B2 was able to grow in the presence of electronic waste and may be “green” agents in the area of circular economy and sustainable development.
Извор:
Book of Abstracts - 21st European Meeting on Environmental Chemistry, EMEC 21, November 30 – December 3, 2021 Novi Sad, Serbia, 2021, 165-165Издавач:
- Belgrade : Serbian Chemical Society
Финансирање / пројекти:
- Министарство науке, технолошког развоја и иновација Републике Србије, институционално финансирање - 200026 (Универзитет у Београду, Институт за хемију, технологију и металургију - ИХТМ) (RS-MESTD-inst-2020-200026)
- Министарство науке, технолошког развоја и иновација Републике Србије, институционално финансирање - 200023 (Институт за технологију нуклеарних и других минералних сировина - ИТНМС, Београд) (RS-MESTD-inst-2020-200023)
- Министарство науке, технолошког развоја и иновација Републике Србије, институционално финансирање - 200168 (Универзитет у Београду, Хемијски факултет) (RS-MESTD-inst-2020-200168)
Институција/група
IHTMTY - CONF AU - Joksimović, Kristina AU - Avdalović, Jelena AU - Zildžović, S. AU - Dojčinović, Biljana AU - Milić, Jelena AU - Lugonja, Nikoleta AU - Beškoski, Vladimir PY - 2021 UR - https://cer.ihtm.bg.ac.rs/handle/123456789/7096 AB - Recycling of electronic waste is crucial not only from the viewpoint of waste treatment but also from aspect of the recovery of valuable metals [1]. The aim of our study was to investigate the potential of using the Acidithiobacillus sp. B2, to solubilize metals (Cu and Zn) from electronic waste. Methodology: Chemical analysis of electronic waste and pyrite The electronic waste (after separating of the plastic parts) and pyrite were pulverized and sieved through a 63 µm stainless steel sieve in preparation for chemical and leaching studies. Electronic waste preparation for the leaching experiment The presence of alkali components in electronic waste is considered inconvenient for the reaction between the electronic waste and the acidic iron(III) sulphate solution. Hence, it is necessary to neutralize the electronic waste before adding the bacterial culture which would generate the oxidant. Before the leaching experiment, electronic waste was dispersed in 0.05 M H2 SO4 solution, shaken for 48 h, filtered from the solution, washed out with deionized water and dried at 110 °C [2]. Preparation of pyrite for the leaching experiments The pyrite concentrate for the leaching experiments was prepared by treating with a 0.5 mol/dm3 sulphuric acid solution (pH ~ 0.5) (solid to liquid phase ratio 1:5 m/V), and mixing with a mechanical stirrer at a room temperature overnight. Then, the solution was decanted, washed with deionized water and dried at 80 °C to a constant mass [2]. Leaching experiments The leaching experiments were carried out with bacterium Acidithiobacillus sp. B2. Experimental conditions were: leaching period of 20 d, 50 ml leaching solution (g/dm3 ): (NH4 )2 SO4 (3), K2 HPO4 (0.5), MgSO4 x 7H2 O(0.5), KCl (0.1), Ca(NO3 )2 (0.01), at a pH of 2.5 in 150 mL Erlenmeyer flasks at a pulp density of 10% (m/V) (5 g leaching substrate in 50 ml solution). The pH of the leaching solution was maintained at a constant value during the leaching process. One half of the substrate was pyrite and the other was an electronic waste. The initial number of microogranisms was 107 per mL, determined by the Most Probable Number method. The control suspension had the same chemical content and pH value as the suspension with Acidithiobacillus sp. B2 but the Acidithiobacillus sp. B2 culture had been inactivated by sterilization. The study was realized on a horizontal shaker. The incubation temperature was 28 °C [2]. Results and conclusions: The results of the effective metal leaching (calculated by subtraction of percentage metal leaching in the control suspension from that in the Acidithiobacillus sp. B2 suspension) are as follows: Zn (38%)>Cu (35%). The obtained results demonstrate that Acidithiobacillus sp. B2 was able to grow in the presence of electronic waste and may be “green” agents in the area of circular economy and sustainable development. PB - Belgrade : Serbian Chemical Society C3 - Book of Abstracts - 21st European Meeting on Environmental Chemistry, EMEC 21, November 30 – December 3, 2021 Novi Sad, Serbia T1 - Microbial Recovery of Copper and Zinc from Wasted Electronic Parts SP - 165 EP - 165 UR - https://hdl.handle.net/21.15107/rcub_cer_7096 ER -
@conference{ author = "Joksimović, Kristina and Avdalović, Jelena and Zildžović, S. and Dojčinović, Biljana and Milić, Jelena and Lugonja, Nikoleta and Beškoski, Vladimir", year = "2021", abstract = "Recycling of electronic waste is crucial not only from the viewpoint of waste treatment but also from aspect of the recovery of valuable metals [1]. The aim of our study was to investigate the potential of using the Acidithiobacillus sp. B2, to solubilize metals (Cu and Zn) from electronic waste. Methodology: Chemical analysis of electronic waste and pyrite The electronic waste (after separating of the plastic parts) and pyrite were pulverized and sieved through a 63 µm stainless steel sieve in preparation for chemical and leaching studies. Electronic waste preparation for the leaching experiment The presence of alkali components in electronic waste is considered inconvenient for the reaction between the electronic waste and the acidic iron(III) sulphate solution. Hence, it is necessary to neutralize the electronic waste before adding the bacterial culture which would generate the oxidant. Before the leaching experiment, electronic waste was dispersed in 0.05 M H2 SO4 solution, shaken for 48 h, filtered from the solution, washed out with deionized water and dried at 110 °C [2]. Preparation of pyrite for the leaching experiments The pyrite concentrate for the leaching experiments was prepared by treating with a 0.5 mol/dm3 sulphuric acid solution (pH ~ 0.5) (solid to liquid phase ratio 1:5 m/V), and mixing with a mechanical stirrer at a room temperature overnight. Then, the solution was decanted, washed with deionized water and dried at 80 °C to a constant mass [2]. Leaching experiments The leaching experiments were carried out with bacterium Acidithiobacillus sp. B2. Experimental conditions were: leaching period of 20 d, 50 ml leaching solution (g/dm3 ): (NH4 )2 SO4 (3), K2 HPO4 (0.5), MgSO4 x 7H2 O(0.5), KCl (0.1), Ca(NO3 )2 (0.01), at a pH of 2.5 in 150 mL Erlenmeyer flasks at a pulp density of 10% (m/V) (5 g leaching substrate in 50 ml solution). The pH of the leaching solution was maintained at a constant value during the leaching process. One half of the substrate was pyrite and the other was an electronic waste. The initial number of microogranisms was 107 per mL, determined by the Most Probable Number method. The control suspension had the same chemical content and pH value as the suspension with Acidithiobacillus sp. B2 but the Acidithiobacillus sp. B2 culture had been inactivated by sterilization. The study was realized on a horizontal shaker. The incubation temperature was 28 °C [2]. Results and conclusions: The results of the effective metal leaching (calculated by subtraction of percentage metal leaching in the control suspension from that in the Acidithiobacillus sp. B2 suspension) are as follows: Zn (38%)>Cu (35%). The obtained results demonstrate that Acidithiobacillus sp. B2 was able to grow in the presence of electronic waste and may be “green” agents in the area of circular economy and sustainable development.", publisher = "Belgrade : Serbian Chemical Society", journal = "Book of Abstracts - 21st European Meeting on Environmental Chemistry, EMEC 21, November 30 – December 3, 2021 Novi Sad, Serbia", title = "Microbial Recovery of Copper and Zinc from Wasted Electronic Parts", pages = "165-165", url = "https://hdl.handle.net/21.15107/rcub_cer_7096" }
Joksimović, K., Avdalović, J., Zildžović, S., Dojčinović, B., Milić, J., Lugonja, N.,& Beškoski, V.. (2021). Microbial Recovery of Copper and Zinc from Wasted Electronic Parts. in Book of Abstracts - 21st European Meeting on Environmental Chemistry, EMEC 21, November 30 – December 3, 2021 Novi Sad, Serbia Belgrade : Serbian Chemical Society., 165-165. https://hdl.handle.net/21.15107/rcub_cer_7096
Joksimović K, Avdalović J, Zildžović S, Dojčinović B, Milić J, Lugonja N, Beškoski V. Microbial Recovery of Copper and Zinc from Wasted Electronic Parts. in Book of Abstracts - 21st European Meeting on Environmental Chemistry, EMEC 21, November 30 – December 3, 2021 Novi Sad, Serbia. 2021;:165-165. https://hdl.handle.net/21.15107/rcub_cer_7096 .
Joksimović, Kristina, Avdalović, Jelena, Zildžović, S., Dojčinović, Biljana, Milić, Jelena, Lugonja, Nikoleta, Beškoski, Vladimir, "Microbial Recovery of Copper and Zinc from Wasted Electronic Parts" in Book of Abstracts - 21st European Meeting on Environmental Chemistry, EMEC 21, November 30 – December 3, 2021 Novi Sad, Serbia (2021):165-165, https://hdl.handle.net/21.15107/rcub_cer_7096 .