Претраживање
Приказ резултата 1-10 од 49
Determination of critical conditions for the formation of electrodeposited copper structures suitable for electrodes in electrochemical devices
(MDPI, 2007)
Electrodeposition of copper from acid sulfate solutions at overpotentials on the plateau of the limiting diffusion current density and at higher overpotentials was examined. The average current efficiencies for hydrogen ...
Effect of codeposition of polymer on the morphology of electrodeposited copper
(Kluwer Academic Publishers, 1979)
Poly(4-vinyl pyridine-co-methyl methacrylate), which is soluble in water in its protonated form and insoluble as a neutral molecule, has been synthesized and introduced into an acid bath for copper deposition. Potential-sweep ...
A Novel Route for Electrolytic Production of Very Branchy Copper Dendrites under Extreme Conditions
(IOP Publishing Limited, 2021)
Copper electrodeposition in a form of powder was examined using the pulsating overpotential (PO) regime from the sulfate electrolyte without or with an addition of various concentrations of chloride ions. Morphological and ...
A new insight into the mechanism of lead electrodeposition: Ohmic-diffusion control of the electrodeposition process
(Elsevier, 2013)
A new insight into the mechanism of lead electrodeposition from nitrate solutions is presented by analysis of the polarization characteristics and by scanning electron microscopic (SEM) analysis of the surface morphology ...
Nanoscale pattern formation during electrodeposition: Ru on reconstructed au(111)
(USA : American Physical Society, 1999)
Scanning tunneling microscopy results on Ru electrodeposition on reconstructed Au(111) are presented, which show a novel type of site-selective nucleation on this surface. At potentials around 0.0 V vs the Ag/AgCl reference ...
The Preferred Orientation of Bright Copper Deposits
(Switzerland : Trans Tech Publications Ltd, 2000)
The preferred orientations of copper deposits obtained from acid sulfate solutions were examined. Mat deposits obtained in the absence of the additives and in the presence of disodium 2-naphtol-3,6-disulfonic acid possessed ...
Anodic deposition of colloidal gold
(Elsevier, 1984)
Colloidal gold solutions were prepared following classical recipes. When electrolysed between graphite electrodes, gold was found to deposit at the anode. The rate of deposition was dependent on the anode potential, on the ...
Nanostructural Analysis of Mirror – Bright Zinc Coatings
(MAIK "Nauka /Interperiodica" (Russia), 2006)
The zinc coatings electrode posited from solution containing dextrin/salicyl aldehyde mixture are
examined by the scanning tunneling microscopy (STM). It is shown that mirror brightness of these zinc deposits is associated ...
Influence of the complex formation on the morphology of lead powder particles produced by the electrodeposition processes
(Elsevier, 2013)
The processes of lead electrodeposition from the basic (nitrate) and complex (acetate) electrolytes were mutually compared by the analysis of their polarization characteristics and by the scanning electron microscopic (SEM) ...
Effect of parameters of square-wave pulsating current on copper electrodeposition in the hydrogen co-deposition range
(Elsevier Science Inc, New York, 2010)
Copper electrodeposition processes in the hydrogen co-deposition range by the pulsating current (PC) regime were examined by the determination of the average current efficiency of hydrogen evolution and by the scanning ...