Приказ основних података о документу

dc.creatorPerić, B
dc.creatorSimonović, A
dc.creatorIvanov, T
dc.creatorStupar, S
dc.creatorVorkapić, Miloš
dc.creatorPeković, O
dc.creatorSvorcan, J
dc.date.accessioned2019-05-31T08:20:24Z
dc.date.available2019-05-31T08:20:24Z
dc.date.issued2018
dc.identifier.issn2452-3216
dc.identifier.urihttps://cer.ihtm.bg.ac.rs/handle/123456789/2927
dc.description.abstractMetal membranes are defined as thin steel circular plates. The metal membranes are widely used in the measurement technique and they are constantly loaded over the entire surface. In case that a membrane is loaded with uniform load over the entire surface. In case that the membrane is stiffened over the edge, then it is called a diaphragm. According to the making method membranes are divided into flat and corrugated. Corrugated membranes are used mainly in a low pressure area. Membranes are most commonly made of firm alloy austenitic steel. In this paper numerical and experimental analysis of a thin corrugated diaphragm 24 mm diameter is presented, with variable material thickness and variable corrugations geometry. Experimental tests are conducted on a corrugated stainless steel (AISI 316) diaphragm. Experimental results are compared with numerical results in ANSYS software package. A comparative analysis of the sinusoidal and toroidal diaphragms has shown that there is a higher sensitivity of the sinusoidal diaphragm, that is, if the thickness of the diaphragm increases, and their stiffness is increased. In general, for small pressure ranges from 10 mbar to 50 mbar, the sinusoidal diaphragms have a faster response. © 2018 The Authors.en
dc.publisherElsevier
dc.relationinfo:eu-repo/grantAgreement/MESTD/Technological Development (TD or TR)/35035/RS//
dc.relationinfo:eu-repo/grantAgreement/MESTD/Technological Development (TD or TR)/32008/RS//
dc.rightsopenAccess
dc.rights.urihttps://creativecommons.org/licenses/by-nc-nd/4.0/
dc.sourceProcedia Structural Integrity
dc.subjectdiaphragm
dc.subjectdeflection
dc.subjectcorrugation
dc.subjectgeometrical parameters
dc.titleDesign and testing characteristics of thin stainless steel diaphragmsen
dc.typeconferenceObject
dc.rights.licenseBY-NC-ND
dcterms.abstractСворцан, Ј; Пековић, О; Воркапић, М; Перић, Б; Иванов, Т; Симоновић, A; Ступар, С; Десигн анд тестинг цхарацтеристицс оф тхин стаинлесс стеел диапхрагмс;
dc.rights.holderThe Authors
dc.citation.volume13
dc.citation.spage2196
dc.citation.epage2201
dc.description.otherEuropean Conference of Fracture - ECF22 - Loading and Environmental effects on Structural Integrity
dc.identifier.doi10.1016/j.prostr.2018.12.141
dc.identifier.fulltexthttps://cer.ihtm.bg.ac.rs//bitstream/id/7107/1-s2.0-S2452321618303767-main.pdf
dc.identifier.scopus2-s2.0-85064596652
dc.identifier.wos000459860900359
dc.type.versionpublishedVersion


Документи

Thumbnail

Овај документ се појављује у следећим колекцијама

Приказ основних података о документу