Porous ceramic monoliths based on diatomite
Samo za registrovane korisnike
Članak u časopisu (Objavljena verzija)
MetapodaciPrikaz svih podataka o dokumentu
Porous silica ceramics were obtained at low forming pressure and low sintering temperature by using diatomaceous earth as a silica source and boric acid as an inexpensive additive. The starting raw material, diatomite from surface coal mine Kolubara, Serbia, was purified from organic and inorganic impurities by using heat and chemical treatment. Boric acid was used as binding and sintering aid up to 2 wt%. Powder was compacted by using different pressures of 40, 60 and 80 MPa. The pressed samples were sintered at 850, 1000, 1150, and 1300 degrees C for 4 h in air. A relatively high porosity in the range of 60-70% is obtained for the samples pressed at 40, 60 and 80 MPa and sintered at 1000 degrees C. Median pore size diameters are in the range of macroporous up to 2 mu m in the samples sintered at 1150 and 1300 degrees C. X-ray diffraction (XRD), Fourier transform infrared (FTIR) spectroscopy, scaning electron microscopy (SEM) and mercury porosimetry measurements were employed to chara...cterize the phases, functional groups, microstructure and pore size distribution of the obtained samples. In addition, measurements of densities and open porosities by immersion technique, according to Archimedes principle, were used. The relations between mechanical properties (Young modulus, Poisson ratio, and compressive strength) versus content of boric acid in the investigated samples were studied and disscussed.
Ključne reči:Sintering / Porosity / Diatomite / Boric acid
Izvor:Ceramics International, 2015, 41, 8, 9745-9752
- Elsevier Sci Ltd, Oxford